Does Curt Channel Mount Coupler # C25328 Fit Standard Channels

Question

Question:

Do all channel mount hitches have the same 2 7/8 - 3inch channel

asked by: Ellis

0

Expert Reply:

In general yes, the channels that the channel mount coupler like part # C25328 attach to are all the same dimensions.

expert reply by: Jameson C

0

Answer 1

The bolts for channel mount coupler #CTA-280 have the markings for grade 8 bolts. They are 5/8 inch coarse threaded bolts so the minimum torque value is 159 and the max is 212 (foot pounds). Once torqued down the force will cause the metal of the…

view full answer...

Answer 2

A little bit of play is acceptable, the coupler should be tight enough that the coupler won't come off the ball, but not so tight you can't close the latch. I typically tighten the coupler up until I feel a slight resistance when closing the…

view full answer...

Answer 3

The Curt Channel-Mount Coupler part #C25328 is designed to be used with an adjustable channel such as the Curt 3-Position Adjustable Channel Bracket part #C48610 which has an inside width of 3". Therefore, the width of the but end on the coupler…

view full answer...

Answer 4

The bolts for channel mount coupler #CTA-400 have the markings for grade 8 bolts. They are 5/8 inch coarse threaded bolts so the minimum torque value is 159 and the max is 212 (foot pounds). Once torqued down the force will cause the metal of the…

view full answer...

Answer 5

The Grade 8 mounting bolts that come with the Trailer Coupler #CTA-280 have a 5/8" diameter and an overall length of 5-1/8" including the head. Without the head of the bolts they measured 4-13/16".

view full answer...

Answer 6

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Does Curt Channel Mount Coupler # C25328 Fit Standard Channels

Product Page this Question was Asked From

Continue Researching