Replacement Spare Wheel/Tire and Wheel Strap for Demco Kar Kaddy 3

Question

Question:

Need selected spare tire for Demco Kar Kaddy 3 along with replacement straps. Are the current ramps be replaced with folding ramps?

asked by: Gary A

1

Helpful Expert Reply:

The correct spare wheel and tire for the Demco Kar Kaddy 3 Tow Dolly is the ST205/75R14 Radial Trailer Tire w/ 14" White Mod Wheel for Demco Kar Kaddy Tow Dolly part # DM5965. The correct replacement wheel strap is the part # DM03528-81. We do not have a replacement ramp for the Kar Kaddy 3.

expert reply by: Jameson C

1

Answer 1

Yes, it is okay to use the polyester replacement Demco tie-down straps. It is a polyester webbing, which is a very common material for straps because unlike nylon webbing, for example, it does not stretch or absorb water, making it really good for…

view full answer...

Answer 2

Hey Pete, thanks for reaching out! As long as you're replacing all of the wheels with the Aluminum Sendel Hi-Spec Series 03 Mod Trailer Wheel #AM22327 it will be safe to switch to the zero offset. If you were to use a zero offset with a positive…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Replacement Spare Wheel/Tire and Wheel Strap for Demco Kar Kaddy 3

Products Featured in This Question

Continue Researching