Determining Torque for Trailer Suspension Components

Question

Question:

Hello, Just installed the dexter EZ 6000 lb kit on my trailer. I had a question about tightening the bolts. You need to tighten them so the splines sink into the bracket, used a impact till head barely touched bracket, any concern with over tightening. I checked torque and they were already there? The shackle seam to move freely, not so sure about the front and rear shackles for the springs. I guess just concerned..... Thank you for your response

asked by: Mike K

0

Expert Reply:

You're good. You want them tight enough that they won't back off but not so tight that the suspension isn't allowed to move like where you are right now.

expert reply by: Jameson C

0

Answer 1

It's not uncommon for new trailer leaf springs to measure shorter than the old leaf springs they are replacing. The reason for this is that leaf springs stretch as they age. Therefore, I do think the 26" long leaf spring options we offer…

view full answer...

Answer 2

It is best to measure your leaf springs with the trailer weight off the spring. As you mentioned you have a measurement of 26.5" from eye center to eye center you more likely have the 25-1/8" Spring #e54SR. If this spring was completely…

view full answer...

Answer 3

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Determining Torque for Trailer Suspension Components

Product Page this Question was Asked From

Continue Researching