Does Westini HDX Grille Guard for 2021 GMC Sierra 2500 fit with Front Sensors and Camera

Question

Question:

Driving to Ak pulling fufth wheel and would like to know if Westin W44NF Grill guard fits 2021 GMC 2500HD SLT 4X4 Duramax Diesel and accomodate grill camera and parking sensors?

asked by: Todd F

0

Expert Reply:

Yes, the Westin grille guard part # W44NF does fit your 2021 GMC Sierra 2500 diesel with the front parking sensors. It would block the front camera though as the mesh would be right in front of it.

expert reply by: Jameson C

0

Answer 1

Hey Lorenzo. Your 2024 Chevrolet Silverado 3500 has what's called Pulse Wave Modulation, which will not provide the wireless cameras with the correct power it needs to run when connected. This is a power saving feature in newer trucks. To fix…

view full answer...

Answer 2

Hey Eric, I know you mentioned you were installing the Vision S+ camera, is the monitor as well a vision S+ monitor or is it the monitor for the old Vision S system? The 2 systems components are not compatible with each other so the camera and…

view full answer...

Answer 3

Hey Manuel! I can help you out with that. The tire you previously ordered from us is the Kenda ST235/75R15 Radial Off-Road Trailer Tire #KE68JR. Did you wear them out taking your trailer off-road or are you looking for a spare?

view full answer...

Answer 4

A high-low adapter isn't always necessary, but it's needed when your tow bar is outside of the "Safe Zone" which is your towed vehicle base plate brackets being within 3" of level with the center of your motorhome hitch…

view full answer...

Answer 5

Since the correct Westin HDX Grille Guard for your 2021 Chevy Silverado 1500 is the part #57-3955 the correct replacement hardware kit would actually be the part #W78XV.

view full answer...

Answer 6

I checked out your 2016 Solitude 321RL and since it has a tapered nose and an extended pin box you wouldn't need a slider hitch installed in the bed of your 2020 GMC Sierra 3500. You could use the B and W Companion Fixed Hitch for GM rail kit…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

Hi Dennis; Fogatti doesn't offer any control codes or specific processes for high elevation with the InstaShower 9 Pro #FG33FR. Here is what they say about high altitude use: If it exceeds 5,000 ft, it shall comply with the requirements of…

view full answer...

Answer 9

Hey George, the correct set of Westin R5 Nerf Bars for your 2026 Chevy Silverado 2500 double cab long bed would be the part #W63FQ which is stainless steel like you are needing as well. Are you up north with a lot of snow and don't want steps…

view full answer...

Answer 10

Good question, Todd! I spoke with Air Lift and the LoadLifter 7500 XL #AL83DQ will have no issues working on a 2025 Ford F350 Crew Cab Dually with the FX4 package. Have you considered an sir compressor system as well? They aren't completely…

view full answer...

Answer 11

Hey, Dave! Happy to help! You want to pick up #WT110108 for the front and #WT27JD for the rear. If you happen to have any sort of steps or running boards, you will want to make sure that there is at least 2" of clearance between any step or…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Does Westini HDX Grille Guard for 2021 GMC Sierra 2500 fit with Front Sensors and Camera

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching