Replacement Tab Arms For Demco Tabless Base Plate Kit # DM34FR

Question

Question:

Where can I buy replacement bolts and nuts for attaching the black clevis to the tabs? Need two 1/2 by 3 inch.

asked by: Jerry M

1

Helpful Expert Reply:

You should consider updating to the Attachment Tabs # DM86MV for your Demco Tabless Base Plate Kit # DM34FR. Demco has changed over to these kinds of tabs in their kits. Otherwise you will need to reach out to Demco directly so they can verify the correct mounting hardware.

expert reply by: Bud M

1

Answer 1

Hey Donziman, so we have three different options for base plate kits that fit your 2024 Ford Maverick. We have the Roadmaster #RM97RR, the Demco #DM77YV, and the Blue Ox #BLU86HR. We don't have an etrailer base plate kit available but (spoiler…

view full answer...

Answer 2

The Brake Light Switch on your 2022 Ford Bronco Badlands is actually not usable for this purpose. There is going to be a work around. The next steps will depend on which Demco braking system you are using. If you are using the Demco SBS Stay-IN-Play…

view full answer...

Answer 3

Hi Ron, welcome back! The Replacement Signal Booster #VAL29RB is compatible with your TM-77. In addition to the listed A1AS, i10, and Smart TPMS it works with the TM66 and TM-77. What happened to your old signal booster?

view full answer...

Answer 4

I have exactly what you are looking for, but the ease of install can be a bit of a loaded question. If you are comfortable dealing with trailer wires such as the occasional splicing or battery terminal connection, then this install will be easier…

view full answer...

Answer 5

You would not be able to charge your battery through the wiring on your 4-way trailer connector. Since your truck has a 7-way connector, you could maintain the power to the battery but not charge it. To begin, you would need to cut off your 4-way…

view full answer...

Answer 6

Yes, you can flat tow your 2017 Jeep Wrangler JK, that has a AEV front bumper, using a Blue Ox #BX1133 Base Plate Kit, as long as your Jeep has the bolt on tabs as shown on page 4 of the Blue Ox installation instructions attached. Most Jeep owners…

view full answer...

Answer 7

There are wiring kits that will work for you, though neither of the kits you referenced are a fit for your 2003 Volkswagen New Beetle. All of the kits available for your vehicle require splicing, such as the Roadmaster Hy-Power Diode Kit #RM-154,…

view full answer...

Answer 8

Hi Jay! While I do have a couple options you can use to add a front hitch to your 2025 Ford E-450 Cutaway with the Jayco 27U conversion, there are no custom fit hitches, unfortunately. With that said, check out the hitch I have below: Curt Class 5…

view full answer...

Answer 9

Hello Brad, thanks for reaching out. Yes the Roadmaster NightHawk tow bar is only directly compatible with Roadmaster Direct-Connect Base Plates. You can adapt it to a Demco tabless base plate using the following: - Roadmaster Sterling or Nighthawk…

view full answer...

Answer 10

It sounds like you are looking for the Replacement Attachment Tabs for Demco Tabless Base Plates #DM86MV. This includes both tabs and are the correct replacement tabs for the Demco Tabless Base Plate Kit #DM9519291.

view full answer...

Answer 11

What you are looking for is the Replacement Attachment Tab for Demco Tabless or etrailer Invisible Base Plates - Qty 1, #DM86MV. This will replace a missing tab, the removeable arm, of your etrailer Invisible Base Plate Kit, #e98948. Please note the…

view full answer...

Answer 12

Thank you for passing on that the Demco tabs part #DM86MV from the etrailer base plate kits like the part #e98955 are a fit for the Roadmaster D-Ring adapter part #RM-031-5. The reason we didn't have them listed as a fit was basically just a…

view full answer...

Replacement Tab Arms For Demco Tabless Base Plate Kit # DM34FR

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching