Will Replacement Signal Booster for TireMinder A1AS, i10, and Smart TPMS Work With TM-77

Question

Question:

Will this work for a tire minder TM-77?

asked by: Ron

0

Expert Reply:

Hi Ron, welcome back! The Replacement Signal Booster # VAL29RB is compatible with your TM-77. In addition to the listed A1AS, i10, and Smart TPMS it works with the TM66 and TM-77. What happened to your old signal booster?

expert reply by: Robin H

0

TM-RHINO
(click to enlarge)

Ron

7/15/2025

Not sure. Bought it used. Hooked directly to the battery but I get no power to the booster.

Robin H.

7/16/2025

@Ron ah I see. There isn't much to this part so the old one is probably dead.

Answer 1

In order to install the Camco Gen-Turi RV Generator Exhaust System part #CAM44461 on a motorhome where the exhaust pipe is turned down towards the ground you'll need to cut that section of the exhaust pipe off. Once this is done, you can use the…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Yes, trailers will have 2 safety chains which helps to keep the trailer centered. For 1/4" grade 70 chain the standard is for it to have a working load limit of 3,150lbs. Since the WLL is 1/3 of the break strength the chains you have are…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...