Will Charger For Bright Way Break Away Battery BW94FR Overcharge Battery On Long Trips?

Question

Question:

Will the battery charger over charge battery on coast to coast trips?

asked by: George

0

Expert Reply:

No, the battery charger included with the Bright Way Breakaway Battery # BW94FR will not overcharge the battery no matter how far you drive. It is designed to allow the battery to fully charge, and then keep it there without damaging the battery.

expert reply by: Samuel C

0

Answer 1

The 1/8" thick tape is most common for side window installation and repairs so I recommend the Alpha Systems Butyl Tape for RV Weatherproofing part #AL42FJ for this. It can always be doubled up if needed. I recommend the 3/16" thick tape…

view full answer...

Answer 2

It sounds like the interior lights on your trailer are powered through the 12 volt circuit on your Ford's 7-way. So, start by testing to make sure that pin is active. On a standard RV style 7-way, this is located at the 1 o'clock position.…

view full answer...

Answer 3

I have some bad news for you Alex. The reason you are having trouble finding an upgrade for your Ventline E-Z Lift Ventadome Trailer Roof Vent #V3092-601-00 is because none exist. This is because the fan and all the bracing are mounted to the top…

view full answer...

Answer 4

The Ventline E-Z Lift Ventadome Trailer Roof Vent #V3092-603-00 is made of all plastic with a few small exceptions like some of the hinge components. This would not have sweat issues in the winter like you described.

view full answer...

Answer 5

Yes, the Rackem Fitz-All Enclosed Trailer Ladder Rack, part number RA-28 will fit your 6 foot wide trailer. The rack installs easily to the trailers rain gutters and fits all trailer brands. These racks are sold as a set which includes 2 load bars…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Will Charger For Bright Way Break Away Battery BW94FR Overcharge Battery On Long Trips?

Product Page this Question was Asked From

Continue Researching