Does Furrion RV Tankless Water Heater Have Heat Exchanger

Question

Question:

I have a Atwood gch10a-4e and you recommend tankless fr98sr, is there a hear exchange?

asked by: Clint

0

Expert Reply:

The Furrion RV Tankless Water Heater part # FR98SR works by heating the water as it passes through the pipes instead of heating a tank of water that eventually runs out. The heat exchanger in tankless water heaters like this are considered secondary heat exchangers.

expert reply by: Jameson C

0

Answer 1

Hey there! You can definitely replace just the jack assembly and keep the original pump system assuming that is all functioning correctly. Something like the #LC63ED would be the replacement for the middle or rear of the trailer on your Lippert Level…

view full answer...

Answer 2

Here is a list of all the Lippert Level Up replacement jacks we offer. Currently this is the only way Lippert offers their jacks and they do not offer a rebuild kit for these. Replacement Hydraulic Jack Assembly for Lippert Level Up RV Leveling…

view full answer...

Answer 3

Hey Tyler, for the Lippert hydraulic jacks like the part #LC63ED you'd want to use Dexron III or Mercon 5 fluid.

view full answer...

Answer 4

With your jacks having the holes on top of the jack going vertically into the jack those are the Generation II jacks from Lippert. Here is a list of all the different Generation II Level Up Jacks available. Black 8K 18-1/2" Replacement Hydraulic…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Hey Micah! Pacbrake has actually been around for a long time, more than 60 years. We have had customers ask for these air bags in the past, and we've seen them on vehicles coming in. Until now, Firestone has been the go to since their quality is…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Does Furrion RV Tankless Water Heater Have Heat Exchanger

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching