How Long Would Install of etrailer Hitch for 2023 Buick Enclave Take

Question

Question:

How long should it take to install this hitch on 2023 enclave? There are sensors in the bumper skin, does unplugging them cause problems? How much should Buick dealer charge to install?

asked by: Tom

1

Helpful Expert Reply:

For most people the install of the etrailer hitch part # e56YR would probably take a couple hours to install. For a dealer though I would assume maybe about the same but they might charge you for two shop hours. The charge would be based on what their current shop hour rate is.

I attached a link to the install instructions as well as a video of the install for you to check out as well.

expert reply by: Jameson C

1

Answer 1

5,000 lbs appears to be the weight capacity of the 2018 Chevy Traverse if it has the 3.6 liter V6 engine and 1,500 lbs if the engine is the 2.0 4 cylinder. Those figures are the fully loaded capacity that your truck can tow. If you are going to be at…

view full answer...

Answer 2

To add a hitch to your 2024 Buick Enclave, I recommend the Draw-Tite item #76184. This hitch is custom fit and bolts to your Buick with included hardware. I really like the Draw-Tite hitch item #76184 because it installs behind your rear bumper cover…

view full answer...

Answer 3

We have two hitch options for the 2020 Chevrolet Traverse to carry a cargo carrier the Curt Trailer Hitch Receiver part #CU29FR, or the etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2" Item #e56YR. These hitches…

view full answer...

Answer 4

Hi Joseph! I understand your frustration, leaving out the brake controller even with the tow package is pretty common. That factory wiring harness will already be hooked up and ready for a brake controller so you won't have to run any additional…

view full answer...

Answer 5

Hey Don, thanks for reaching out! I checked out the owner's manual for your 2025 Traverse and according to page 258 it says "if equipped" and there are blunt cut wires that need to be spliced into. This means you'll need to hardwire…

view full answer...

Answer 6

The 2020 Chevy Colorado 4x4 can be flat towed. The 2wd version cannot. The owners manual on page 300 states to " Only dinghy tow four-wheel-drive vehicles that have an N (Neutral) and a Four-Wheel Drive Low (4 (n) setting." On the dial you…

view full answer...

Answer 7

Hey Alban, since you have a Blue Ox tow bar #BX7365 already and their flat towing setups are really nice and easy to use I would recommend going with a Blue Ox base plate kit like the part #BLU85CR which is a fit for your 2024 Chevy Colorado. For…

view full answer...

Answer 8

Hey James, thanks for reaching out! According to my research, your 2024 Chevy Colorado Trail Boss meets the requirements to be flat towed (it has a two-speed transfer case), but if the plow frame you're talking about is something you had…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...