Can The Turret Be Replaced On A Reese Sidewinder To Fit A Different Bolt Pattern
Updated 02/28/2023 | Published 02/26/2023
Question:
Hello, I’m not sure if you can help me or not. I was given a sidewinder pin box by a friend of mine that wasn’t using his. My question is, my trailer has a fabex 520 pin box on it now. How do I tell what turret the sidewinder I was given has, and is it the right turret for the fabex 520? If I figure out it’s not, can I replace just the turret with the correct one. The sidewinder is an older non air ride pin box. Thank you
asked by: Brian G
Expert Reply:
The SW16K part number only correlates to the Sidewinder and not the turret. There should be another sticker somewhere that lists a code like ST100, ST200, ST300, ST400, or ST500 to let you know which turret you have.
You can replace the turret with part # RP61300-01 to be compatible with a Fabex 520 bolt pattern.
(click to enlarge)
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: curt 16027
- Shop: Dometic Soft Start for Penguin II Electronic Air Conditioner Setup - Single Zone - Qty 1
- Shop: Replacement Hall Effect Sensor Wire Harness for Lippert Ground Control 3.0 - Rear Driver's Side
- Shop: Curt A20 5th Wheel Hitch w/ S20 Slider for Ford and Chevy/GMC Prep Package - Dual Jaw - 20K
- Shop: Adapter Rails for Curt 5th Wheel Hitch - Ford and Chevy/GMC Towing Prep Package
- Shop: Adapter Rails for Curt 5th Wheel Hitch - Chevy/GMC Towing Prep Package
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector - Preorder
- Shop: Trailer Wiring