Can Two Square Direct Weld Jacks 25-3/4 Lift - 10K Be Used Together

Published 02/23/2023

Products Featured in This Question

etrailer Square Sidewind Trailer Jack - Drop Leg - 12-3/8" Lift - 10,000 lbs

(301)

$256.77

etrailer Square Trailer Jack - Side Pin Drop Leg - 12-1/4" Lift - 10,000 lbs

(301)

$247.53

Question:

Can two of these jacksfoot crank handles be tied together to work in parallel? If so, is there a recommended pipe section to use to tie the units together?

asked by: Westley

Expert Reply:

The Square Direct Weld Jack part # TJD-12000SP-F2 can be used in tandem. The only thing you would need to do this would be a cross shaft which would be some sort of bar that attaches the two output shafts to one another. This is assuming you want both jacks to turn at the same time and not have independent operation with two handles. We don't have any cross shafts for this but you should be able to find the parts locally as it's just a steel pipe with holes drilled to pin the pipe to the shafts.

If you'll be use two of these jacks tied together, you won't need two handles so I recommend the Square Direct Weld Jack part # TJD-12000SP-R2NH for the second jack.

expert reply by: Conner L