Search: rv antifreeze   >  

The lugs of a sewer pipe fitting can not be fixed so you would have to completely replace the fitting. To do that you'll have to first empty out the tank, which since your lug fitting has broken off will require you to hold the hose in place…

I confirmed with Dometic that the Replacement Single Zone Thermostat for Dometic RV Air Conditioners part #DMC79FR has an internal temperature sensor.

I recommend that you first remove the current lock and identify the cutout measurement. I have two optons listed below and which one you need is based on your cutout dimensions. Be aware that entry door locks are not a tight tolerance fit, so the cut…

I suggest pulling the 12 volt DC fuse and let it sit for 15-20 minutes to try and hard reset the 4900N MaxxFan Deluxe Roof Vent. You should check all the wires and connections for damage like corrosion, shorts or overheating. If this doesn't work…

Yes, the MB Sturgis Quick Disconnect Propane Hose #100476-120-MBS has a threaded male Disposable Cylinder connector on one end (see photo please) that will mate with the female Disposable Cylinder connector on the adapter shown in your photo. The…

In order to find an exact replacement for the exterior baggage door latches on your 2003 Damon Intruder Motorhome I would need some sort of part number to reference. The latches you have now look very similar to the Lippert Components Slam Latch…

There is a connector available to connect the P3 controller to the Range Rovers under dash connector for brake controller installation. You can order the P3 #90195 and the proper wiring #3035-P. The connection point for the brake controller wiring…

Curt Class III hitch #13456 will fit your LR3 with a 2-inch receiver. This is a no-drill installation and you can refer to the linked instructions and the install video showing a 2006 LR3 to see the process. For a trailer brake controller I recommend…

No the MAXX AIR II Vent Cover #MA86JR that you referenced does not come with a bug screen built into it. Just the screen is not available as it does not separate.

The MaxxAir FanMate RV and Trailer Roof Vent Cover #MA00-955002 will fit your MaxxAir 00-04900K, but it will not allow the lid to fully open. This is a clearance issue that is the same for every other RV roof vent on the market. Manufacturers will…

We've heard that your latch is a bit over sized. Can you check to see what size cutout it fits into? We may have a solution but if it's larger than 3 inch wide by 4 inch tall nothing we'd offer would fit.

We sure can! The Transcom #TCM 21344 TB cross references to the 10-10 seal we offer, part #RG06-090. The seal has a 2.125 inch ID and a 3.376 OD. It's compatible with a 25580 inner bearing.