Mounting Hole Dimensions of Curt Trailer Hitch C14048 for Cab and Chassis

Published 02/02/2023

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"

(13)

$295.53

Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver - Weld On - Class V - 2"

(42)

$296.73

Question:

What is the total length of curt hitch 14048 from the front bracket to the rear bracket, front mounting hole to end of rear bracket and outer width? I have a 2020 Thor ACE on an F-53 chassis that is a 34inch frame width with 17inch from end of frame to the rear spring shackle mount. The current hitch is listed as a class IV with 8000lb/ 500lb tw rating and I am looking for a hitch with a higher tw.

asked by: Brooke W

Expert Reply:

In regards to the Curt Trailer Hitch Receiver part # C14048, the distance from the center of the front mounting hole to the center of the rear mounting hole is 17-1/4". The distance from the center of the mounting holes left to right is 31". I have attached a photo below with these measurements. Unfortunately, we don't have any measurements to the end of the flange.

If you're looking for a trailer hitch for an F-53 Chassis, I recommend a service body hitch like the Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver part # 41990-16 since there are no custom fit options for this. The service body hitch will need to be welded or drilled and bolted.

expert reply by: Conner L