Replacement Circuit Board for a MaxxFan Roof Vent Model 4951KS

Question

Question:

There were two options for a replacement board for mine. It appears that my board is a 4751ks and it appears that my controller does not have a reverse, so it looks like I need the MA10A04751ks. I don't want to order the wrong one.

asked by: Robert T

1

Helpful Expert Reply:

Thanks for reaching out!

Since you have the 4951KS model MaxxFan roof vent you'll need the Replacement Printed Circuit Board for MaxxAir MaxxFan Plus Roof Vents # MA10A04751KS. The circuit board might look slightly different as far as the pieces on it but this isn't uncommon for roof vents that have been around a while. Usually the difference is better parts on the newer design.

This board has 2 different 2-pronged connectors as well as 2 bare wires for the installation. I've attached a review video for you to check out!

expert reply by: Jon G

1

Frame on MaxxFan 4951KS Model
(click to enlarge)

Control Options on MaxxFan 4951KS Model
(click to enlarge)

Circuit Board for MaxxFan 4951KS Model
(click to enlarge)

Answer 1

The Furrion #FMCM15SS is a great appliance that will meet your needs. I researched the dimensions of your original Dometic and discovered they are 29 15/16" wide x 16 7/16" tall x 15 3/8" deep. The Furrion I'm recommending will fit…

view full answer...

Answer 2

Hi John, So unfortunately your Greystone range hood CXW-30-CZ01 does not have parts available as it is obsolete. That does mean you would need to replace it with a different range hood. The Greystone is a vented 22" wide range hood, and a…

view full answer...

Answer 3

Toyota didn't offer a factory 7-way option for the 2006 Tacoma, so your 7-way was either aftermarket or dealer-installed. I'm assuming that your 7-way is already tapped into the lighting circuits. Look under the dash for a coiled up blue…

view full answer...

Answer 4

When you are hardwiring a trailer brake controller like the Prodigy P2 #90885 the red wire connection that provides the triggering signal to the controller should be made to the wire on the COLD SIDE of the brake light switch circuit. This is the…

view full answer...

Answer 5

The Dometic 320 Full-Timer RV Toilet #DOM87FR has an overall height of 18-1/4", an overall depth of 22", and an overall width of 14-3/4". RV toilets are essentially universal parts so you'll just have to make sure you have room for…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Replacement Circuit Board for a MaxxFan Roof Vent Model 4951KS

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching