Length of Aries Round Nerf Bars for a 2006 Toyota Tundra Access Cab

Question

Question:

Can you tell me the dimensions of your nerf bars. Mine are Westin Brand 68 and 3/4 inches long. Most say they are 71 inches long.

asked by: SANDRA R

1

Helpful Expert Reply:

I called Aries about the Aries Round Nerf Bars part # AA202003-2 which are a fit for a 2006 Toyota Tundra Access Cab and they said they are 71" long for end to end.

expert reply by: Conner L

1

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 8

Hey Gary. The Draw-Tite Front Hitch item #65031 is going to mount a bit higher on your 2004 Toyota Tundra compared to the Curt item #31180. The Curt Front Hitch item #31180 is 14-3/4" off the ground when measured from the top of the inside of…

view full answer...

Length of Aries Round Nerf Bars for a 2006 Toyota Tundra Access Cab

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching