Replacing Valves Only On Bristol Double RV Waste Valves 34466ND13AAR

Question

Question:

Hi: Do I have to replace the entire valve system? My leak is only from the housing of black tank valve. Leak only occurs when the black valve is fully extended. Can I just replace this portion? Is it possible to only replace the black tank valve? Thanks

asked by: Randy L

0

Expert Reply:

In regards to the Bristol Double RV Waste Valves part # 34466ND13AAR, you can replace both the black valve section using the Bristol Waste Valve Body for RV Black Water part # 34439240 and the grey valve section using the Bristol Waste Valve Body for RV Gray Water part # 34439241.

expert reply by: Conner L

0

Answer 1

Hey Timothy, here's the instructions for removing the cable assembly of a Valterra waste valve like the part #VAL54MB: Remove the locknut from the cable housing assembly. Feed the cable through the mounting bracket or hold in the wall of chassis.…

view full answer...

Answer 2

Hey Bladen, is it possible to use a slightly longer cable? We don't have 36 inch but we do have a 48 cable for a Valterra valve with the part #VAL64GB.

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 10

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Replacing Valves Only On Bristol Double RV Waste Valves 34466ND13AAR

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching