Replacement Snap-Up Lever For Equal-i-zer Weight Distribution Hitch  

They're pretty much the same. The Equal-i-zer Weight Distribution System w/ 4-Point Sway Control item #EQ37100ET weighs 109 lbs and the Reese Steadi-Flex item #RP66559 you were looking at weighs 112 lbs. Equal-i-zer does make a tool that will…

I recommend using the Equal-i-zer Weight Distribution System #EQ37100ET while towing your 6,000lb trailer with 800lbs of tongue weight. I have some tricks which will help to make this much easier for your wife to hook up and still give her a safe…

Reese doesn't offer a spring bar handle as a replacement part for the #RE44FR weight distribution kit, but luckily the Equal-i-zer #EQ95-01-6050 would work for you.

In order to find a weight distribution hitch for your 2020 Forest River Wildwood you will need to know your tongue weight. Tongue weight is the most important factor when it comes to determining the correct system. Tongue weight is typically 10-15%…

The correct spring bar lift tool for a Reese weight distribution system is the Snap Up Handle part #RP58162 and not the Curt #C17112 that you referenced.

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…