95" Long Axle With 80" Spring Center With Electric Trailer Brakes and a 5 on 4-3/4" Bolt Pattern  

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…

It is likely that the red wire on your old lights is the turn signal/brake light wire, and the black wire is the running light wire. That would make the white wire the ground. You can verify this by testing the wires using a circuit tester such as…

For 3,500 lb axles you will use 10 inch assemblies. My recommendation is the Electric Trailer Brake Kit - Self-Adjusting - 10" - Left and Right Hand Assemblies - 3,500 lbs #AKEBRK-35-SA for each axle. These assemblies will work well for your…

Yes they are! The Dexter Electric Trailer Brake Assembly #23-180 (Left Hand) and #23-181 (Right Hand) are made in the USA; the accompanying photo is from one of these assemblies with the "Made in U.S.A." sticker on it. These electric brake…

Your StarCraft trailer would have to be overloaded and/or you would have to hit a pretty severe bump for the leaf springs to deflect beyond what they are designed for. SInce there is a chance this could happen, albeit a small one, having some extra…

For your 2022 Grand Design 22RBE with dual 3,500 lb overslung dexter axles the correct SumoSpring kit is part #TSS-107-40. Since your trailer is a tandem axle you will need two of these kits. These are made specifically for overslung axles rated…

Thanks for all of the info and the research you've already done! Dropping almost 2" from about the point where the king pin connects to the Demco Hijacker 18K #DM69GV or 21K #DM89GV back towards the end of the bed is definitely enough to…

The amount of space needed is going to vary depending on the spring that you use. If you use the Timbren Trailer Suspension Enhancement System Light-Duty Trailers 1,000 lbs #TTRA1702, those springs are only 2-3/4" tall so you can get away with…

Congrats on the new truck! There are a couple of options to lift your 2020 Montana High County depending on if your axle's sit above or below the leaf springs. If your axles are already below your leaf springs the only option is the Correct Track…

The Aluminum Lynx Trailer Wheel pat #LHSL301 fits what you are looking for. It's 15 by 5 inch, has a 5 on 4-1/2 inch bolt pattern, is silver, and is spoked. For a somewhat similar option we have the part #AM20455 as well. These are both nicer…

We do indeed carry axles with a 95 hub face and 80" spring center. Knowing that it is a 5 lug hub, you are likely dealing with a 3,500 lb rated axle. If you want to confirm this you could always measure the diameter of the axle tube. A 3,500 lb…

Although they are not rated significantly higher, installing the #e57SR could result in a noticeable difference in the ride. Springs rated for your 3,500 lb axle (1,750 lb spring capacity) would be the better option. I'm not sure what you had…