Replacement Rear Header Assembly For TruXedo Lo Pro On A 2007 Ford F-150

Question

Question:

Correct Replacement Rear Header for Truxudo Lo Pro QT for 2007 Ford F-150 6.5ft bed

asked by: Chris A

0

Expert Reply:

The Replacement Rear Header Assembly for TruXedo Lo Pro Soft Roll-up Tonneau Cover # TX578101-REARHEADER is the correct header assembly for your 2007 Ford F-150 6-1/2 foot bed.

expert reply by: Noah E

0

Answer 1

The latch assembly that you see in the picture I attached for the #TX578101-REARHEADER is included when you order this.

view full answer...

Answer 2

In order to replace the rear header on your TruXedo Lo Pro Soft Roll-up Tonneau Cover - Black #TX584101 you'll want to use the Replacement Rear Header for TruXedo Lo Pro Soft, Roll-up Tonneau Cover #TX5841-RearHeader. Unfortunately your cover…

view full answer...

Answer 3

Hey Rick, thanks for all of the info you gave us on your Truxedo tonneau. Based on that the correct rear header you'd need is the part #TX5691-RearHeader.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hey Nelson, so you would need two separate systems since a supplemental braking system can only be used with a towed vehicle and a trailer brake controller can only control trailer brakes. Main difference is a supplemental braking system is designed…

view full answer...

Answer 12

Hey Micah! Pacbrake has actually been around for a long time, more than 60 years. We have had customers ask for these air bags in the past, and we've seen them on vehicles coming in. Until now, Firestone has been the go to since their quality is…

view full answer...

Replacement Rear Header Assembly For TruXedo Lo Pro On A 2007 Ford F-150

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching