Are Replacement Springs Clips Available For A Ventline Ventadome Roof Vent

Question

Question:

Good morning, I am looking for a replacement spring clip for a ventline ventadome trailer roof vent with wedge shaped plastic dome. Thank you,

asked by: Tom D

0

Expert Reply:

I went ahead and checked to see if we carry any replacement spring clips for your Ventline Ventadome trailer vent, and unfortunately that is not offered as a replacement.

Ventline has confirmed in the past that in order to get new spring clips you'd need a full replacement lid like the Ventline E-Z Lift Ventadome Trailer Roof Vent # V3092-601-00.

expert reply by: Bryce D

0

Answer 1

Just the clip on the end of the Replacement Operator #BV0115-04 is not available separately. Only option is an all new operator with the #BV0115-04 you referenced.

view full answer...

Answer 2

You did indeed see a video showing how to replace the vent lid #BVD0449-A01. I have linked that video for you here as well. IT was one that I made a while back and that is probably where you saw it.

view full answer...

Answer 3

I found some photos of the Heng's Roof Vent 122112 online. Based on this, it looks the correct replacement for you should be the Vent Cover for Ventline Old Style Rounded Dome Trailer Roof Vents part #BV0554-01 for white or part #BV0554-03 for…

view full answer...

Answer 4

The only thing I can think of that could cause an issue like this is that you have indicator light wired incorrectly to something that has power when not connected to the motorhome. In the typical setup you would connect the power for the indicator…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Are Replacement Springs Clips Available For A Ventline Ventadome Roof Vent

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching