Will The Furrion RV Power Cord Adapter # FP52GEN4RSB Fit A Honda EU7000is Generator 120/240v Port

Question

Question:

will the male 4 prong 30 amp plug fit into the Leviton 125/240 volt L14-30 receptacle found on a Honda EU7000is generator.

asked by: Joseph K

1

Helpful Expert Reply:

From what I can see the 120-240v port on the Honda EUY7000is generator is a twist lock port so the Furrion RV Power Cord Adapter - 50A Female to 30A 4-Prong Male # FP52GEN4RSB is a compatible fit.

expert reply by: Kevin C

1

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

I looked up the dimensions of your High Pointe EC942K9E and it's 15 inches deep, 15.7 inches tall, and 29.9 inches wide so the Furrion Over the Range RV Convection Microwave #FMCM15SS that you referenced would easily fit in place of it and would…

view full answer...

Answer 6

Hello Jason, thanks for reaching out. Yes, the Portable Power Watchdog Surge Protector with Bluetooth and WiFi #HU32VR can be used with a generator. One thing you will have to note is that some generators have a ‘floating neutral’. This might cause…

view full answer...

Answer 7

The rubber bumpers on the head of a 5th wheel trailer hitch like the Pro Series 16k, #PS30096, are designed to prevent and/or limit contact between components on the hitch. You can install 2 more but really only 2 are needed. Adding 2 more can limit…

view full answer...

Answer 8

The Replacement Rubber Bumper for Reese Fifth Wheel Trailer Hitch, part #30536, attaches to the head with a screw that gets pressed down through the top of it and then is attached on the underside of the head with a nut. I have provided links to the…

view full answer...

Answer 9

Hey Steven, We do have a custom 5th wheel base rail kit for your 2020 Ram 1500 that will not require any drilling into your truck's frame, and the correct part number for that is the following: - Curt Custom Fifth Wheel Installation Kit for Ram…

view full answer...

Answer 10

The #FR93FR, FWH09A-AM, FWH09A-1-A are all the same Furrion Tankless Water Heater. since you're wanting to reuse the door and wall controller you'll want the #FR93FR to save yourself the money on the door. It will however still come with the…

view full answer...

Answer 11

Hey Thomas, thanks for reaching out! According to my research your 3,900 lb axle should use the same bearing parts as a 3,500 lb axle so you should need the Hub Bearing Kit for 3,500 lb with #84 Spindle #BK2-100. This uses an L68149 inner bearing, an…

view full answer...

Will The Furrion RV Power Cord Adapter # FP52GEN4RSB Fit A Honda EU7000is Generator 120/240v Port

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching