Camera Observation System that Fits Pre-Wiring of Winnebago 2108DS RV  

I have attached for you below the pairing procedure for the Voyager WiSight Wireless RV Backup Camera System part #ASA84YR. Please note, a mistake I have made in the past was applying power to the camera too soon, this cannot be done until the…

Since your Winnebago Micro Mini is pre-wired for a Voyager camera setup the correct part is the Voyager WiSight 2.0 Wireless Backup Camera System w/ Night Vision for Prewired RV #ASA37YR.

For your 2021 Winnebago 2108DS pre-wired for a Voyager back-up camera I recommend the Voyager WiSight 2.0 Wireless Backup Camera System #ASA37YR. This wireless backup camera system is designed for RVs/Travel Trailers with factory-installed Voyager…

For additional rear facing style cameras to use with the Voyager Wisight part #ASA37YR that you plan to install on your 2021 Winnebago Minnie you'd want the Replacement camera part #ASA74YR which you could use in any of the locations you…

There isn't an adapter to connect the wiring of a Furrion camera to a Voyager. With that said you can pretty easily just cut the connectors off and then connect to the camera since it's only two wires.

Your 2020 Winnebago Minnie is pre-wired for a Voyager Camera System and I specifically recommend the Voyager WiSight Wireless RV Backup Camera #ASA37YR.

The Voyager WiSight Wireless RV Backup Camera System #ASA37YR you were looking at is only compatible with the RV Backup Camera #ASA74YRor #WVH100 so this would need to be the camera you already have installed or you would need to replace the camera.…

All the brake controller needs to sense a trailer connection so that you can test it is a slight amperage draw on the output circuit. For that you can use a circuit tester like the part #PTW2993 with one pin grounded and the other on the output pin.…

GM did not include a plug-in style brake controller connection until the Silverado came out in 1999, so I doubt your 1998 Z71 has a brake controller port. Prior to 1999 brake controllers had to be hardwired to GM trucks and SUVs. Since you already…

I was able to find the following produce for adjusting the pendulum on the Kelsey Brake Controller: "Depress the brake pedal just far enough to illuminate the tow vehicle brake lights. Use a finger to pull the pendulum leveling arm (a small…

The 2000 Chevy C/K Series does not have a plug in the relay box or under the dash to plug a brake controller adapter into. To wire in a brake controller like part #90195 it would be a hardwired application. To accomplish wiring in the brake…

I went out to the warehouse with the writer who wrote the description for the Trailer Valet, #STC-V211, to determine if our stock is the old or new version. I am happy to report that we have the new version. The manufacturer states the following…