What Hitch Fits My Non-AWD 2022 Volkswagen Taos?

Question

Question:

I also don't know where to take my vehicle to get that hitch put on my car so I can use my 1UP USA bike carrier! I hope I figure it out soon! Thanks so much again for responding twice.

asked by: Lila T

0

Expert Reply:

Definitely! We have a great hitch that fits a non-AWD 2022 Volkswagen Taos. For that recommendation, I suggest the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" # C38JR. This hitch has a ton of advantages over the competitor Draw-Tite # DT79GR. First off, the Curt Hitch does not require and drilling to enlarge the bolt holes. Lastly, since the gloss overcoat over the base powder coat offers more protection than the Draw-Tite, you get more overall protection against rust and corrosion. To top it all off, the Curt hitch is assembled in the U.S.A. while the Draw-Tite is assembled overseas.

expert reply by: Bob C

0

Where to Find Local Installers
(click to enlarge)

Lila T.

1/1/0001

I also don't know where to take my vehicle to get that hitch put on my car so I can use my 1UP USA bike carrier! I hope I figure it out soon! Thanks so much again for responding twice.

Bob C.

4/11/2022

Not a problem! If you plan to use the hitch for a bike rack, there is an additional consideration to make: the shank length of the rack. This is important because you need to have enough length on your 1UP rack in order to clear the rear bumper with the Curt Hitch # C38JR installed. With the # C38JR, the center pinhole of the hitch is 5-1/2 inches from the rear face of your bumper. I recommend measuring your bike's shank from the center of the pinhole (where you put the pin to attach it to the hitch) to the closest part of the rack. It is important to do this measurement with the rack folded up if the rack has a folding mechanism in it in order to be accurate. That measurement needs to be more than 5-1/2 inches long in order to clear the rear bumper. If it is less, I recommend using the Hitch Extender For 2" Trailer Hitch Receiver 7" # HE06 for extra length on the shank. It is important to note that if you use this extender, it will decrease the hitch's weight capacity to 100 pounds of tongue weight. As far as where to get the hitch installed, there is a way to check for our local installers in your area! There is text underneath the product photos/videos that reads "Need help with installation? Locate installers near me." I went ahead and attached a photo that shows where this is located. From that link, you can find local installers that we recommend near your zip code.

Answer 1

Hey Gregor, yeah we have great tilting bike racks that would fit your Subaru Outback from the super nice Thule Epos bike rack part #TH49XE which is very easy to use and loaded with features to the Economical Malone Runway part #MPG2130. Or the tried…

view full answer...

Answer 2

Certainly; I have added a cutout for you showing the fascia trimming needed on your 2024 Volkswagen Taos to install the Curt hitch that fits. I verified with the manufacturer for you the correct part number is the following: - Curt Trailer Hitch…

view full answer...

Answer 3

When the center mast on the Curt #C18085 is folded down it measures about 10-1/2". This is from the bottom of the shank that goes into the receiver on your 2016 Ram ProMaster and was taken with the 2" adapter on. So if you have a 2"…

view full answer...

Answer 4

Hello Tim, Congrats on the new VW! Yes, you can most definitely install a trailer hitch on the back of your 2025 VW Taos. The hitch that you were looking at the #DT79GR is a great fit, but it looks like it is on a bit of a back order and wouldn't…

view full answer...

Answer 5

The trailer hitch you referenced, Curt Class I hitch #C11055, is a confirmed fit for your Fiesta sedan. This hitch for your Fiesta sedan is a light-duty 1-1/4-inch Class I hitch suitable for use with a hitch-mount 2-bike rack or a cargo carrier for…

view full answer...

Answer 6

According to the owner's manual for your 2014 Ford Fiesta Hatchback, this vehicle is not approved for trailer towing. That said, there are others who tow with this vehicle and I can understand you needing to get you belongings from New York to…

view full answer...

Answer 7

Hey Mark, The Draw-Tite Max-Frame Trailer Hitch Receiver #DT79GR and Curt Trailer Hitch Receiver #C38JR would be the only two options we currently offer. Of the two the Draw-Tite #DT79GR is going to be the better option. Both come with mounting…

view full answer...

Answer 8

If the VIN was removed, you do have a couple options. First, check any documentation you received with the trailer, especially if any registration or title/bill of sale type paperwork was included. If there isn't anything like this or there is no…

view full answer...

Answer 9

In cases where a VIN can no longer be found on the trailer itself (you can try also looking along the length of the trailer's frame, both outside and inside, and on the axle for an ID tag/sticker) and there isn't one on your title then your…

view full answer...

Answer 10

I prefer the Curt Trailer Hitch Receiver #C38JR over the Draw-Tite Max-Frame Trailer Hitch Receiver #DT79GR for your 2023 Volkswagen Taos. The Curt is made in the USA while the Draw-Tite is manufactured overseas. Both receivers have a similar design…

view full answer...

Answer 11

I looked up your 2023 Cedar Creek 377BH and since it has a tapered nose and your 2024 Chevy Silverado 2500HD has a "longer" short bed you could easily get away with a fixed hitch and have enough turning clearance. The GVWR is a little over…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

What Hitch Fits My Non-AWD 2022 Volkswagen Taos?

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching