2-1/2" Round Trailer Lights that are Recessed Mounted and Rubber Grommet for 2-3/4" Hole
Updated 03/18/2022 | Published 03/17/2022
Products Featured in This Question
Question:
I have a PJ trailer that needs new clearance lights and gromets. The holes in the trailer for the lights measure 2 3/4. Would part # A57GB Gromet and MCL59AB and MCL59RB lights fit?
asked by: Mike B
Helpful Expert Reply:
Yes, the Rubber Grommet for 2-1/2" Round Trailer Lights - Recessed Mount, # A57GB requires a 2-3/4" diameter cutout for installation and allows you to use a recessed mounted 2-1/2" diameter sealed light such as the LED Trailer Clearance or Side Marker Light, # MCL59AB or # MCL59RB.
Product Page this Question was Asked From
LED Trailer Clearance or Side Marker Light w/ Reflex Reflector - Submersible - 8 Diodes - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 2-1/2 Inch Diameter
- Amber
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Trailer Taillight Lens with SAE STIAP2 04 DOT DOT Number On It
- Q&A: Recommended Replacement for Atwood G6A-7 Water Heater
- Q&A: Clearance Light Recommendation for 2-1/2 inch Hole In Flat Bed Truck
- Q&A: Choosing Proper Set Angle for Replacement Dexter Torsion Axle.
- Q&A: Trailer Hitch Ground Clearance On 2014 Volkswagen Jetta SportWagwen
- Q&A: How to Wire a Trailer Break Away System and Connect Auxillary Battery and Brake Wires
- Q&A: Replacement LED Marker Lights for Floe Pro 100 14 Foot Snowmobile Trailer
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Lighting Requirements
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices