Recommended Trailer Jack With Foot for Homemade Utility Trailer
Updated 03/14/2022 | Published 03/12/2022 >
Question:
Hi, I was looking at this jack for my little homemade utility trailer. Do you have a version of this that doesnt have a wheel? Note: I dont weld, and there is no connector to attach circle mount jacks. Thanks
asked by: Michaelle
Expert Reply:
For a jack that is similar to the Round Swivel Marine Jack # MJ-1206B I recommend the Pro Series Round, Snap-Ring Swivel Jack # PS1400300303. This jack has a footplate instead of a wheel and has a 2,000 lb lift capacity.
This features a bolt on installation and fits up to a up to 3" x 4" trailer tongue. The jack has an 11" retracted height, 21" extended height, and 10" of lift. The # PS1400300303 is also a swivel jack so you will be able to swing the jack up for travel and back down when you need to use it.
Product Page this Question was Asked From
etrailer Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1,000 lbs
- Trailer Jack
- Boat Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Sidewind Jack
- 0 - 1000 lbs
- Manual Jack
- 10 Inch Lift
- Bolt-On
- With Wheel
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: fulton 141133
- Q&A: Looking for a Bolt-On Jack That is Less Than 11 Inches When Attached
- Q&A: Is a Replacement Gear Housing Available for the Fulton F2 Swing-Up, Wide-Track Trailer Jack?
- Shop: Fitted Sheets for Thule Approach L Rooftop Tents - Gray
- Shop: Replacement Sidewind Handle for etrailer and Ram Square, Direct Weld Jacks - 3K - 7K
- Shop: Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs
- Shop: Round Snap Ring Swivel Jack w/ Footplate - Bolt On - Black - Topwind - 10-1/2" Travel - 2K
- Shop: Stabilizer Jack - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 1
- Shop: 2-Piece Exterior Wall Vent for Enclosed Trailers - Polypropylene - 3" Diameter Hole - Black
- Article: Best Boat Trailer Jacks
- Q&A: Distance From Hitch Pin Center to Beginning of Drop on Draw Tite Ball Mount 40332
- Article: Trailer Lighting Requirements
- Q&A: Recommended Hydraulic Jack Leg That Can Be Used w/a Hydraulic System on a Dump Trailer
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure a Trailer Axle
- Q&A: What is Torque for 3,500 lb Axle U-Bolts
- Q&A: Is There A Hitch Extender For 2.5" Hitch With A 7,500lb GTW Capacity
- Q&A: Availability of Replacement Grease Seal 450133
- Article: Rooftop Cargo Carriers
- Article: Trailer Maintenance Schedule
- Article: Trailer Jacks


