Replacement 2 Inch Convert-A-Ball Compatible With 1 Inch Shank

Question

Question:

I need a 2 in stainless convert-a-ball for a 1in shaft I see one on your web page but not sure if it is for a 1 in shaft

asked by: Robert J

0

Expert Reply:

I'm guessing you already have the 1 inch shank, and you're looking to add a 2 inch stainless Convert-a-ball, is that correct?

If so, you'll want to use # 401B which is compatible with 3/4 or 1 inch diameter shanks.

expert reply by: Mike L

0

Answer 1

If the vehicle's towing capacity is lower than the trailer hitches towing capacity, then that will need to be the figure you abide by and vice versa. You always need to abide by the weakest component in the towing setup. The reason for this is…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

For your 2024 Nissan Frontier I recommend the Redarc Tow-Pro Liberty Brake Controller #RED24FR. I like the Liberty because it is simple, reliable, and looks great in any vehicle. The main unit installs behind the dash, so only the control knob will…

view full answer...

Answer 8

Hey Jonathan, congrats on the new truck! The Universal Mounting Panel item #331-TPSI-001 is what you'll need to install the control knob of the Redarc Tow-Pro Liberty item #RED53CR in your 2026 Nissan Frontier SV. It measures 1-8/16" tall x…

view full answer...

Answer 9

Hey Alexander. The Universal Mounting Panel item #331-TPSI-001 is what you'll need to install the control knob of the Redarc Tow-Pro Liberty item #RED53CR in your 2024 Nissan Frontier. It measures 1-8/16" tall x 1-1/8" wide. There are…

view full answer...

Answer 10

Thanks for the pictures! I have exactly what you are looking for. We have a couple of mounting options for the control knob that can go inside inserts in your Subaru's dash. This will give you a clean factory look install. The Universal Mounting…

view full answer...

Replacement 2 Inch Convert-A-Ball Compatible With 1 Inch Shank

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching