Surface Prep for Alpha Systems 4034 Roof Coating for RV Roofs

Question

Question:

Can this product be applied right from the container or do you have to apply a primer first?

asked by: Thom

1

Helpful Expert Reply:

The Alpha Systems 4034 Roof Coating for RV Roofs, # AL34CV applies with a brush or roller and adheres to polyurethane foam, aluminum, galvanized steel, fiberglass, cured concrete and EPDM roof membranes. The manufacturer does list requiring a primer to first be applied. But does state to ensure surface is clean, dry, and free of moisture or oils before application.

expert reply by: Michael R

1

Answer 1

Hey Brad, like with all RV AC units the actual temperature probe is built into the controller of the AC unit and not the wall mounted thermostat. So the part #FR33PR will not relocate the sensor like you are wanting.

view full answer...

Answer 2

Good morning, Diane. That is a good question since the RockyMounts HighNoon #RKY87RR and the RockyMounts MonoRail #RKY10007 are quite similar. The HighNoon is essentially the newer version of the same RockyMounts bike rack. We started selling the…

view full answer...

Answer 3

It sounds like you have a 1998 Nash 26J. Based on what I have found this has a GVWR of 7,000 lbs which tells me you have 3,500 lb axles. Assuming that is the case, you will more than likely need Hub Bearing Kit for Lippert, Dexter, and Al-Ko Axles -…

view full answer...

Answer 4

The rule of thumb here in most cases is, the smoother the surface and glossier the paint, the shorter the nap. With the roof of the trailer being fairly smooth a 3/4" or less nap would be the better option. The manufacturer recommends a…

view full answer...

Answer 5

Hello David, Thanks for writing in! The Dicor Metal RV Roof Elastomeric Coating #DC75XR covers 200 square feet per gallon, per coat, and you will want to apply two coats for maximum performance. So if you have a 200-square-foot roof, you will need…

view full answer...

Answer 6

Hey Ray! Since you tried out a different vehicle and had the same issue we can rule out the vehicle side. The first thing I would do is check your ground connection and make sure it is secure. After that, I would go ahead and hook it up, run your…

view full answer...

Answer 7

Most slides have EPDM rubber roofs but because EPDM is rubber it requires treatment each year to keep it soft and prevent shrinkage. You could replace it with TPO which is another synthetic rubber that will last longer than the EPDM. The smallest…

view full answer...

Answer 8

Hey Alex. From the information I can find online it does look like your 2011 Keystone Cougar 318SAB does come prepped for a second AC unit. The bedroom roof vent should be reinforced and pre-wired for a 13.5k or 15k BTU unit. To check if your trailer…

view full answer...

Answer 9

Hey Rodney, For a rubber roof you can use the Alpha Systems 1021 Self-Leveling Sealant for RVs #AL98KV. This is self-leveling sealant so it's design to pool a bit before drying and would only be good for use on the roof. If you're needing any…

view full answer...

Answer 10

Yes, it does Matthew! The Weigh Safe 180 Hitch 2-Ball Mount for 2.5" Hitch item #WS74MR is designed for and will only fit a 2-1/2" receiver.

view full answer...

Answer 11

Without knowing what the coating is made of there's no way to confirm what would actually stick to it. We currently only offer the Alpha Systems 4034 Roof Coating for RV Roofs #AL34CV, which is ok for use on polyurethane foam, aluminum,…

view full answer...

Surface Prep for Alpha Systems 4034 Roof Coating for RV Roofs

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching