Is It Possible To Manually Raise Lippert C-Jack For Lippert Ground Control TT

Question

Question:

Can you operate these jacks Manually using 12 bolts only, no computer

asked by: Jim K

0

Expert Reply:

Yes, the Replacement C-Jack for Lippert Electric Ground Control TT # LC404488 can be operated manually if a switch happens to go bad or you lose power.

To operate manually, you'll first need to disconnect the battery before continuing. Next, disconnect one of the wires from the motor to prevent back feeding.

Next, insert the Replacement Manual Crank Handle for Lippert 5th Wheel RV Landing Gear # LC119226 over the coupler and pin at the end of the stabilizer jack. The slot in the end of the crank handle accommodates the pin on the coupler to allow the manual extension/retraction of the stabilizer jack.

Finally, rotate the handle clockwise and begin extending jack, or counter-clockwise to retract jack.

expert reply by: Bryce D

0

Lippert C-Jack Operation
(click to enlarge)

Answer 1

The part #LC304136 that you referenced is the replacement module for the Lippert Ground Control 3.0 electric leveling system #LC358590 with 4 jacks. Since it sounds like you have a setup with 6 jacks and two of them show similar behavior my Lippert…

view full answer...

Answer 2

I spoke with my contact at Lippert regarding the error message issue you are having with your Ground Control Leveling System. He says it sounds like the controller may have gone bad. To check this you can cut power to the controller and just do a…

view full answer...

Answer 3

Sounds like you have a Lippert Ground Control setup installed on your motorhome. Typically with issues like this Lippert recommends unplugging the control panel which should look like #LC175225 for a few seconds to let it reset and then plug it back…

view full answer...

Answer 4

In order to test the controller on the Lippert Ground Control 3.0 Electric Leveling System you'll first need to obtain a multimeter. Once you have this then you will need to use the ground probe and place that on the green wire coming from the…

view full answer...

Answer 5

Since the left side jack of your Lippert Ground Control 3.0 is not responding, and you have checked the fuses, since you mentioned switching the harnesses around and the issue then occurred on the other side I would say that is the issue over a…

view full answer...

Answer 6

It does sound like the Control Module #LC304136 for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC675817 is the issue on your Salem Hemisphere. Since you have confirmed all the fuses and voltages are correct on the system…

view full answer...

Answer 7

If you have reset the system and they are still not retracting, you will need to check a few things. First will be the fuses. If one or more of these have failed, it can cause the system to not function properly. Next will be ground connections. A…

view full answer...

Answer 8

The part you are referring to is a circuit breaker, not a relay. In order to test the circuit breaker all you need to do is probe the blue wire that feeds this and then the red wire which is the output. If you get 12 volts on the red output wire…

view full answer...

Answer 9

There are a few possible reasons as to why you can't get your Lippert Electric Jack #LC285318 (this is essentially the current version of your 181794) to extend. While possible, I doubt the leg as simply been jammed due to a lack of lubrication.…

view full answer...

Answer 10

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

Hey Tim welcome back! Your ARH15AACBL2 GE AC unit has the old 410a refrigerant in it so the GE Appliances item #GE64FR you were looking at isn't going to work as a replacement. The EPA mandated R32 refrigerant has been used in all new AC's…

view full answer...

Is It Possible To Manually Raise Lippert C-Jack For Lippert Ground Control TT

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching