Replacement A-Frame Tongue Jack That Fits Three Hole 3" Mounting Bolt Pattern

Updated 01/11/2022 | Published 01/10/2022

Products Featured in This Question

Lippert Quick Drop Tongue Trailer Jack - A-Frame - Topwind w/ Drive Nut - 14" Lift - 2,000 lbs

(49)

$73.38

Ultra-Fab Speed Socket Power Drill Adapter for Scissor Jacks

(179)

$12.34

Question:

Hi, Im replacing the current Jack on my trailer and wondering if the bolt hole on the mounting plate on the mounting plate for yours will fit mine? The current Jack mounts to my trailer using 3 bolts he bought equally spaced, 3 inches on center. Thoughts?

asked by: Jon E

Expert Reply:

The 3" bolt hole spacing is the standard pattern for mounting bolt holes on most trailers. The Lippert Quick Drop Tongue Jack # LC733926 that you are looking at will match that same pattern. Do note that the holes on the jack are oblong to account for slight variations in the size.

One thing I do recommend verifying is the diameter of the tube going though the hole. The Lippert jack has a 2-1/4" outer tube diameter. I have seen some older and small trailers only have a 2" diameter hole and the more common 2-1/4" jack will not fit. If that is the same case for you the hole will need to be enlarged to fit the larger diameter jack.

The Speed Socket Power Drill Adapter # UF48-979005 will fit the head on the Lippert jack to quickly raise and lower the jack.

expert reply by: Bud M