Is Weight Distribution Needed for Towing a Rockwood Hard Side Pop-Up Camper
Updated 01/12/2022 | Published 01/10/2022 >
Products Featured in This Question
Question:
I have a 2014 Honda Ridgeline sport 4,491 lbs per specs online. We purchased a hard sided pop up camper, dry weight 2,014 lb - hitch weight 222 per specs online What kind of weight distribution hitch If any do we need. I was going to purchase weigh safe with Built in scale, but it’s confusing since it talking about weight of your trailer loaded. How would I know that??? Do I need to buy a scale too? I have 2” ball. Thank you
asked by: Denise I
Helpful Expert Reply:
The first thing I would recommend is checking the owner's manual of your 2014 Honda Ridgeline Sport to see what it says about using a weight distribution hitch. In general, a WDH is recommended if your trailer weight is more than 50% of your vehicle's GVWR (gross vehicle weight rating) or if you are experiencing rear sag and trailer sway. It looks like the curb weight of your Ridgeline is the 4,491 lbs you looked at, and the GVWR is 6,050 lbs.
The dry weight for your camper is the completely unloaded weight. I do not know what year or exact model you have there, but it looks like an A122S Rockwood Hard Side pop-up. These list a cargo carrying capacity, which is the maximum amount of weight you can carry in your camper. You would add this to your dry weight to find the GVWR. It looks like for this camper that would put you over 3,000 lbs so, assuming that is correct and you fully load it, a WDH would be a good idea as far as weight is concerned. This is just an estimate so you will need to find this using the model and year of your camper.
When it comes to choosing a WDH the most important factor is the tongue weight. Tongue weight is typically 10-15% of the trailer weight. We already know that the lowest is going to be 222 lbs, and the highest, assuming you load it to the max, will be around 450 lbs. More than likely, you will be somewhere in the middle of that range. If you want to know exactly, you can use the bathroom scale method, a scale like the # e99044, or like you said some Weigh Safe ball mounts have a built-in scale. I have attached a helpful article on how to measure tongue weight which outlines different methods.
Even without actually weighing it it is safe to say a WDH like the Fastway e2 Weight Distribution # FA92-00-0450 would be a good fit. This system uses 2 point sway control and is rated for tongue weights up to 450 lbs. So, unless you are exceeding the 450 lb tongue weight limit of this system it would be a great choice. You would also need a hitch ball like the # 40038 since one is not included. You can use the 2" ball you already have as long as it has a 1" diameter shank.
I have attached some review videos, along with some helpful articles on weight distribution for you to check out.
Featured Help Information
Miscellaneous Media






Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Brake Controller
- Article: Brake Controller Installation: Starting from Scratch
- Search Results: 18136
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Trailer Wiring
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Shop: Redarc Tow-Pro Elite Brake Controller - Dash Knob - Off-Road Mode - Up to 3 Axles - Proportional
- Shop: Curt MV Weight Distribution System - Round Bar - 6,000 lbs GTW, 600 lbs TW
- Q&A: Troubleshooting Trailer Lights with Only the Right Turn Signal Working
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Q&A: Turn Signals on Trailer Not Working When Running Lights are On
- Q&A: Troubleshooting Trailer Lights that Blink with Ignition Off and Not Work with Ignition On
- Q&A: Troubleshooting Trailer Wiring Where Running Lights Only Work
- Q&A: Right Turn Signal on Vehicle Activates Left Turn Signal on Trailer
- Q&A: Troubleshooting No Turn Signals with a Curt Trailer Wiring on a 2011 Chrysler Town and Country
- Q&A: Driver's Side Taillights Don't Work Once Curt C56331 Trailer Wiring Harness Is Installed
