High Capacity 3 inch Lunette Ring that Fits Channel Mount

Question

Question:

I need a 3 pintle hitch that bolts in a channel hitch on my RV. Rating 30K to 40K pounds. Do you manufacture tgis hitch?

asked by: Dallas C

0

Expert Reply:

The highest rated 3 inch lunette ring we have that fits channels is the part # DM09557-95 which has a 25k capacity.

expert reply by: Jameson C

0

Answer 1

I confirmed with my contacts at Gen-Y Hitch that Gen-Y Hitch Pin #325-GH-099 tow rating is 32000 lb (shear strength) without the reducer sleeve. This hitch pin is designed for use with 2" by 2" and 2-1/2" by 2-1/2" hitches.

view full answer...

Answer 2

Hi Jim, Yep, you can definitely use the Gen-Y Anti-Rattle Clamp for 2-1/2" Hitch Receivers #GY28XR. It isn't technically rated for anything specific, but can be used for all towing purposes, including your weight distribution hitch. There…

view full answer...

Answer 3

Attached is a dimensional diagram of both the 15 Ton #337BP125A and 25 Ton #337BP225 Buyers Products Swivel Type Pintle Hooks. The diameter of the bolts holes are 0.53".

view full answer...

Answer 4

It appears your Northstar Ironbull Deckover Dump DDP9616072 comes with a 3" channel bracket which will accept the Buyers Products Lunette Ring #337B16140. If you have a different size channel or different mount please let me know as I am going…

view full answer...

Answer 5

Thanks for the picture Richard, I can tell by your picture you have a Model 6 surge actuator on your trailer which the #T4846500183 is the correct replacement for if you were wanting a channel style inner slide member replacement.

view full answer...

Answer 6

Yes, the Curt Lunette Ring #C48600 will fit great with your Demco 5-Position Adjustable Channel Bracket #DM13867-52. To install the ring you can use the Curt Bolt Kit #C48620.

view full answer...

Answer 7

I did some digging and I cannot find any info on if there is a brake controller port under the dash of your truck. Doesn't mean there isn't one but I can't find any info on it or any other year F-650 as well. I'd be inclined to…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

High Capacity 3 inch Lunette Ring that Fits Channel Mount

Product Page this Question was Asked From

Continue Researching