Rhino Rack Crossbar Install Locations On 2019 Mazda CX-9

Question

Question:

There are 3 mounting points on the roof 1,2,3. I want the racks to be as far apart as possible, that is mounted to 1 and 3. And they need to be level. Is this possible?

asked by: Brendan

0

Expert Reply:

I spoke to Rhino Rack about using the Rhino-Rack RVP Roof Rack for Fixed Mounting Points part # RRRVP51 on a 2019 Mazda CX-9 and they stated you must use the forward and middle mounting points. The last mounting point is only used when there are three crossbars. The crossbar spread if using the first and last mounting point would be too large for most accessories.

expert reply by: Conner L

0

Answer 1

Yes, there is a set of crossbars that will fit the factory side rails of your 2023 Mazda CX-9. These mount directly to the side rails and will have more than enough capacity for a bike rack or cargo box. You will want the roof rack by Rhino Rack and…

view full answer...

Answer 2

Rhino-Rack does have an RVP rack fit for your 2019 Mazda CX-9 with flush mounted roof rails with the Rhino-Rack RVP Roof Rack for Fixed Mounting Points #RRRVP51.

view full answer...

Answer 3

Yes, we do have a set of crossbars that mount directly to your side rails and don't extend past them. They are the Rhino-Rack RVP Roof Rack for Fixed Mounting Points item #RRRVP51. This aero bar roof rack system has a 165 lbs capacity. The…

view full answer...

Answer 4

The Rhino Rack RVP roof rack part #RRRVP51 is a confirmed fit for your 2018 Mazda CX-9 and does attach to the fixed mounting points the vehicle has on the roof. I attached a picture that I took from the linked install instructions (see below) that…

view full answer...

Answer 5

The Rhino-Rack RVP Roof Rack for Fixed Mounting Points part #RRRVP51 comes with two crossbars, one for the front and one for the rear. The crossbars are not the same so it dose matter which goes where. I wasn't able to find any refence to this…

view full answer...

Answer 6

I checked with Rhino Rack and they have confirmed the fit of the RVP roof rack part #RRRVP51 on your 2022 Mazda CX-9.

view full answer...

Answer 7

Yes the Rhino Rack RVP roof rack part #RRRVP51 that you referenced is a fit for your 2020 Mazda CX-9 without chrome side rails and does attach to factory fixed mounting points.

view full answer...

Answer 8

Thanks for the photo, and there is nothing that comes with the rack specifically would go over the factory moldings of your 2021 Mazda CX-9 when installing the Rhino-Rack RVP Roof Rack for Fixed Mounting Points #RRRVP51. That said, per the…

view full answer...

Answer 9

For a great roof rack for mounting a roof top tent on your 2019 Mazda CX-9 with fixed mounting points, I recommend the Rhino-Rack RVP Roof Rack for Fixed Mounting Points - Vortex Aero Crossbars #RRRVP51. It is important to note that the dynamic…

view full answer...

Answer 10

I spoke with my contact at Rhino-Rack who said that they don't have any notes about there being any issues between the part #RRRVP51 and the moon roof on a 2019 Mazda CX-9 but she did say that you need to be careful not to overtighten the…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Rhino Rack Crossbar Install Locations On 2019 Mazda CX-9

Continue Researching