Roof Rack Recommendation for a 2020 Porsche Macan With a Sunroof

Question

Question:

Best roof top rack which allows sunroof operation while installed. Car is 2020 Porsche Macan.

asked by: Tony B

0

Expert Reply:

I am partial to the Yakima roof rack. It has extra adjustments that the other rack companies do not have to provide a better fit for your vehicle. This Yakima rack will allow you to open your sunroof provided the roof rack accessories do not interfere with its operation. The rack for your 2020 Porsche Macan will consist of the following:

Yakima JetStream Crossbars - Aluminum - Black - 60" Long - Qty 2, part # Y00426,
BaseLine Towers for Yakima Crossbars - Naked Roofs - Qty 4, part # Y28TR,
BaseClip Fit Kit for Yakima BaseLine Roof Rack Towers - Qty 2, part # Y06163,
BaseClip Fit Kit for Yakima BaseLine Roof Rack Towers - Qty 2, part # Y06189, and
Yakima Same Key System (SKS) Lock Cores (QTY 4), part # Y07204.

This roof rack has a weight limit of 165 lbs. It comes with the JetStream crossbars which are elliptical in shape to help with wind noise and fuel efficiency. These crossbars have a t-channel so they will work with most channel mounted accessories as well as traditional roof rack accessories that clamp the crossbar. I included the Yakima Same Key System Lock Cores so you can secure this rack to your vehicle. If you do get roof rack accessories that require lock cores you can request the same key.

If your rack does have raised rails the same thing applies, some roof rack products may cause interference with your sunroof. However, this roof rack will be a bit different. You will use the same locks, but the crossbars, towers, and fit kits. This rack will consist of the following:

Yakima JetStream Crossbars - Aluminum - Silver - 50" Long - Qty 2, part # Y00428, Black, part # Y00425,
SightLine Towers for Yakima Crossbars - Flush Side Rails - Qty 4 part # Y64AR,
SightClip Fit Kit for Yakima RidgeLine Roof Rack Towers part # Y72CR, and the Yakima Lock Cylinders.

This roof rack has the same weight limit of 165 lbs. I have included product description links video review links, and from Yakima, a picture of a 2020 Porsche Macan with the sunroof open and a Yakima rack installed below.

expert reply by: Mark Smith

0

2020 Porsche Macan With Panoramic Roof Outfitted With Yakima Roof Rack, picture courtesy of Yakima
(click to enlarge)

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 5

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 9

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 10

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 11

Hey Jason, whenever available I would recommend going with the channel attachment for roof rack accessories including the Thule Hullavator part #TH898 as its simpler stronger, and it's basically the future of most roof rack accessories as it…

view full answer...

Answer 12

Hello John, thanks for reaching out. Yes, we do have a Thule roof rack that will allow you to install the Hullavator #TH898 on your 2015 Subaru Forester. For that I recommend the following: - Thule WingBar Evo Roof Rack for Raised Rails - Aluminum -…

view full answer...

Roof Rack Recommendation for a 2020 Porsche Macan With a Sunroof

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching