Replacement Drive Head And Idler Head Covers For Old Solera Powered Awning

Question

Question:

Can you help with this replacement?

asked by: Mark S

0

Expert Reply:

You are going to need the Solera Awning Plain Drive Head Front Cover # LC289557 and Back Cover # LC289558 for your awning. Due to your covers being the oldest style that Lippert made they are no longer available and this is the updated cover.

If you would like for your other side to match you need the Solera Awning Plain Idler Head Front Cover # LC289563 and Back Cover # LC289564

expert reply by: Bud M

0

Cutomer Image 1
(click to enlarge)

Customer Image 2
(click to enlarge)

Answer 1

Meg, for your Lippert Solera 2000 series awning you can use the Replacement Front Cover for Lippert Edge Awnings #LC32NJ for the front and #LC43UD for the rear to replace your damaged cover. Also, if by cap you're meaning the manual override…

view full answer...

Answer 2

Yes, we do have a replacement cover for a Lippert 3000 series awning. You will need the Replacement Front Cover item #LC37FR.

view full answer...

Answer 3

The best solution we have for your situation is a new manual crank drive head for your Solera manual awning since the gears aren't available. For that you'd want the black drive head part #LC300031.

view full answer...

Answer 4

The gearbox inside of the Solera Manual Crank Style Awning Drive Head part #LC300031 is not available separately as a replacement part therefore if you need to replace this you will have choice but to replace the entire assembly.

view full answer...

Answer 5

When installing the Solera Manual Pull Style Awning Drive Head, Black #LC272067 you will want the spring to be under some tension when completing the installation so that it draws the awning back fully once you've completed the installation. My…

view full answer...

Answer 6

I called and spoke to the technician at Lippert about the gear packs. If the arms that attach to your slide out are 2 x 2 you will need Gear Pack part #LC281331. If the arms that attach to the slide out at 2.5 x 2.5 you can certainly use Gear Pack…

view full answer...

Answer 7

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Answer 8

I can definitely help with that, Larry! There are differences between the Roadmaster Comfort Ride Kits #RM-2460-2580-3 #RM69NQ and #RM-2460-2570-3 and I have them listed below. They all include the Comfort Ride Shock Absorbers for Tandem Axle…

view full answer...

Replacement Drive Head And Idler Head Covers For Old Solera Powered Awning

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching