Replacement Parts for Bulldog Square Jack
Updated 07/28/2015 | Published 07/27/2015
Products Featured in This Question
Question:
Bulldog 12 Jack on 30 foot goose neck trailer, Landing gear has slid out and no longer retract? Assumed it was held in by spring, and was looking for replacement and Diagram showing how it attaches?
asked by: Matt W
Expert Reply:
The replacement parts we have for the Bulldog Square Jack # BD182500 are a Replacement Gear Kit # BD500212 and a Replacement Screw and Nut Kit # BD500217. These are the two most likely aspects of the jack to be causing your problem.
I have attached the only two diagrams we have related to this trailer jack. The inner tube is held to the outer tube by the screw and nut assembly.
Product Page this Question was Asked From
Bulldog Square Jack - Fixed Leg - Sidewind - 12-1/2" Lift - 10,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Side-Mount Jacks
- Steel
- 9001 - 10000 lbs
- Manual Jack
- 12-1/2 Inch Lift
- Weld-On
- 1 Jack
- Bulldog
more information >
Continue Researching
- Shop: Caliber EdgeGlide XL Transition Plates for Enclosed Trailers - 96" Long - Qty 4
- Search Results: hopkins 40955
- Shop: Truck Bed Auxiliary Tank
- Shop: Kenda Karrier KR35 ST225/75R15 Radial Tire w/ 15" Split Spoke Aluminum Wheel - 6 on 5-1/2
- Search Results: demco trailer brakes
- Search Results: demco coupler
- Shop: Global Link RV Entry Door Locking Latch Kit with Keyed Alike Option - Black
- Search Results: light box
- Search Results: plastic fender
- Search Results: electric jack
- Search Results: smittybilt
- Shop: Gen-Y Hitch Nomad 5th Wheel to Gooseneck Pin Box - Lippert Rhino - 30K GTW - 6.5K TW
- Shop: Caliber EdgeGlide XL Transition Plates for Enclosed Trailers - 72" Long -
- Shop: etrailer Gooseneck Coupler w/ Load Bearing Pin - 8" Adjustment - 2-5/16" Ball - 30K
- Shop: etrailer Electric Trailer Jack - Drop Leg - A-Frame - 22-1/2" Lift - 3,500 lbs
- Shop: Lift Assist
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wiring
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Q&A: Replacement Jack Rod and Nut For 10k/12k Trailer Jack
- Shop: Suspension Enhancement
- Shop: Tool Box
- Shop: Fifth Wheel Hitch
- Q&A: How to Remove Pin in Handle Shaft to Replace Gears on an Older Bulldog Model 12 Square Jack
- Video: Comprehensive Review: Replacement Lifting Nut for Curt Heavy Duty Direct Weld Square Jack
- Q&A: Installation Instructions for Bulldog Powered-Drive Kit # BD1824200100
- Q&A: Troubleshooting A Roll Pin That Won't Slip Into Place In A Bulldog 10K Square Jack
- Shop: Gooseneck Hitch
- Q&A: Troubleshooting Bulldog Electric Landing Gear that Turns But Does Not Raise or Lower Jack
- Q&A: What is the Inner Diameter of Replacement Thrust Bearing for 12K Bulldog Square Trailer Jacks