Replacement Driver and Passenger Side Tow Dolly Fenders For a Demco Tow-It 2

Question

Question:

Will this fender also fit the Demco Tow-it 2inch 2017 tow dolly? It appears the same but nothing in the literature provides alternate uses!

asked by: Don G

0

Expert Reply:

I was able to find the correct fenders for your Demco Tow-it 2 tow dolly, as the Replacement Fender # DM97FR will not fit your Tow-it 2.

Passenger Replacement Fender # DM66MV

Driver Replacement Fender # DM76MV

expert reply by: Bud M

0

Answer 1

We sure do! To match the passenger side Replacement Fender Assembly for Demco Kar Kaddy 260/360 Tow Dolly #DM32VR, you'll just need the Replacement Fender Assembly for Demco Kar Kaddy 260/360 Tow Dolly #DM52VR for the driver side. Both of these…

view full answer...

Answer 2

I'm so sorry to hear about your fenders! We do carry the replacement you need for your older Demco Kar Kaddy 260 tow dolly. The passenger's side fender replacement you need is the #DM32VR. This fender also comes with the assembly for the LED…

view full answer...

Answer 3

We do have a couple of replacement fenders that fit 14" wheels and would work great for you depending on what tow dolly you have. If you have the Demco Kar Kaddy SS Tow Dolly with Disc Brakes #DM9713045, you can use the Replacement Fender…

view full answer...

Answer 4

While the CE Smith Single Axle Trailer Fender #CE17920 may be able to fit your tow dolly, it will be best to try and find the fender that is specific to your tow dolly. Tow dolly fenders will have lights built into the fenders as well as inner fender…

view full answer...

Answer 5

The difference between the models will depend on which ones you are comparing to the Kar Kaddy SS. The Kar Kaddy SS will have built-in LED lights and a galvanized gray finish. While some of the other models will not have LED lights and some have a…

view full answer...

Answer 6

For the driver side you'd want the part #DM37FR and for the passenger side #DM97FR according to my contact at Demco who verified the dimensions you are in need of.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Replacement Driver and Passenger Side Tow Dolly Fenders For a Demco Tow-It 2

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching