Can Furrion Tankless Water Heater be Used at Higher Altitudes

Question

Question:

My Furrion water heater will be used above 5000 ft to8000ft the orfas is set at factory 4000ft

asked by: Gary F

1

Helpful Expert Reply:

Tankless water heaters like the Furrion part # FR98SR can be used at higher altitudes but the output will be slightly diminished. So you can use this at your altitude but it may not be quite as powerful.

expert reply by: Jameson C

1

Answer 1

With the newer model Air Lift LoadLifter 5000 Ultimate Air Springs #AL88365 they have internal bumpers. This makes for a much cleaner look and works just as good if not better than the factory bump stops as it protects your bags from…

view full answer...

Answer 2

As a rule of thumb for any altitude over 4000ft high, a gas tankless unit will lose 4% of its BTU for every 1,000ft above this height. To troubleshoot this issue you can replace the orifice with a smaller one to keep the oxygen to gas ratio correct…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

I sure do Ronnie and welcome back! The Dexter Nev-R-Adjust Electric Trailer Brakes item #23-458-459 are exactly what you need. These self adjusting set of brake assemblies will replace the 12" ones currently on your Airstream trailer. They have…

view full answer...

Answer 10

Yes, it will Clay. The Lippert Hub Bearing Kit item #LC35ZP is designed for 6,000 lbs hubs. It includes the outer bearing item #15123 and inner bearing item #25580 that come with 6,000 lbs Timbren hubs. The Lippert Hub Bearing Kit item #LC35ZP also…

view full answer...

Answer 11

Hey Brandon, thanks for reaching out! The brake controller plug for your 2025 Ram 1500 is under the dash to the right of your steering column, according to the installation instructions for the Curt TriFlex NEXT Trailer Brake Controller w/ Custom…

view full answer...

Answer 12

Hey Joe, welcome back! With a 35" wheelbase the MORryde AllTrek 4000 Equalizers for Tandem Axle Trailers #MR29DR is the correct fit. I verified your Reflection has 6k axles on the Grand Design parts site so the #APUBR-8 is also correct and so is…

view full answer...

Can Furrion Tankless Water Heater be Used at Higher Altitudes

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching