Should You Wire Go Power Solar Panels In Parallel Or Series

Question

Question:

I have the same system, but watched videos on YouTube from BTBRV and NRVTA. Where they installed the system on JDs RV, but in there video they said they wired the solar panels in series when the go power Manual clear shows them in parallel. Who is correct? Because a pwm solar controller normally requires a parallel connection and three panels in series would exceed the max voltage of the pwm controller. I commented on both their videos but never got a response.

asked by: Stephen B

0

Expert Reply:

Systems with a 30 amp solar charge controller or lower are run parallel while systems with a higher amp solar charge controller can be run in series or series parallel. The Go Power Solar Extreme Charging System - 570 Watt Solar Panels - 3,000 Watt Inverter Charger Item # 34282185 you linked to has a 30 amp solar charge controller so it will be3 wired in parallel.

expert reply by: Kevin C

0

Answer 1

I went out to the warehouse and measured the single unit #TL11001 of the Pin Locks #TLS9500 that you referenced and found the width to be 1-7/16" but to the rubber grommet measured 1-1/4". If you need 1-1/8" of space then these will…

view full answer...

Answer 2

The Go Power MPPT Solar Charge Controller #GP72RR is our only Go Power MMPT 30 amp controller. This will work with the Bluetooth Remote Display #GP37MR which is the GP-RVC-R.

view full answer...

Answer 3

The vast majority of RV roof vents do measure the common 14 x 14-inch size and fit a roof opening that is slightly larger, 14-1/4 x 14-1/4-inches typically. The item you mentioned, Ventline tinted replacement lid #BVD0449-A03, is for this vent size,…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The differences between the Firestone Ride Rite #F2613 and the Red Label #F2709 for your 2023 GMC Sierra 3500 Crew Cab Long Bed is the air pressure and max weight capacity. The Ride-Rite #F2613 are rated for 5,000lbs and 100 PSI, where the Red Label…

view full answer...

Answer 11

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 12

Hey Donny! For your Dometic Penguin/Brisk Air 15,000 BTU AC model B59516.711C0-MX, the correct soft start is the #DMC93JF. This is designed for Dometic Brisk II electronic air conditioner units with in-wall thermostats.

view full answer...

Should You Wire Go Power Solar Panels In Parallel Or Series

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching