Does Wesbar 102641 Replacement Lens Include Side Marker Lens

Question

Question:

Does this replacement lens come with the side lens as well?

asked by: Jason

0

Expert Reply:

The Wesbar # 102641 replacement lens provides a rear lens for the # 403076 or # 403026. The replacement side marker lens is sold separately as part # A17RB.

expert reply by: Mike L

0

Answer 1

I went out into our warehouse and pulled an Optronics Replacement Tail Light Lens #A16RB and a Wesbar Replacement Lens #053522033360 and compared the two and found they are virtually identical. Check out the video I attached that shows both of these…

view full answer...

Answer 2

Hi Mike, The Replacement Red Lens for Wesbar Submersible Trailer Tail Lights for Trailers Over 80" Wide #102641 is just the rear-facing lens and does not include the side lens. The lens seen in the customer photo is part #A17RB, which is…

view full answer...

Answer 3

We have just what you need. For the replacement lens you need the part #102641. For the side marker cover you need the part #A17RB for the 403076 light.

view full answer...

Answer 4

From your image that you sent in it appears to be the Wesbar Low Profile Trailer Tail Light #403076 on your boat trailer. For just a lens we have the Replacement Red Lens #102641 which will be just the lens that you see in the image. There is also…

view full answer...

Answer 5

Sounds like you are looking for the replacement side marker lens part #A17RB. This is the replacement side lens that fits the style Wesbar 1026 light you have.

view full answer...

Answer 6

The dimensions of the Wesbar Replacement Red Trailer Light Lens #102641 are 8 x 2-13/16. This lens is a direct-fit replacement for their light models #403076 and #403026.

view full answer...

Answer 7

Since Harbor Freight and HaulMaster are not actual manufacturers they will use existing products from OEM makers like Optronics and re-brand them. So quite often a replacement light lens from one brand will fit the light of another. I checked on the…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Does Wesbar 102641 Replacement Lens Include Side Marker Lens

Continue Researching