3/4 Shaft Amber Keel Rollers

Question

Question:

Will you please let me know if you have the amber wobble rollers available for 3/4inch shafts?

asked by: Lonnie N

0

Expert Reply:

Yes, we do have the Amber wobble rollers available. The CE Smith Ribbed Wobble Rollers are 4" Diameter, fit a 3/4" Shaft and are available in Amber Item # CE29536.

expert reply by: Jerred H

0

Answer 1

We have a 5 inch diameter Yates Wobble Roller that fits a 3/4 inch diameter shaft. For that you'd need the #YR500YW-6P and you'd be set.

view full answer...

Answer 2

We have the Yates Ribbed Wobble Roller in either a Heavy-Duty Rubber #YR530R-6P or Thermoplastic Rubber #YR500YW-6P. These both are 5" in diameter, 3" wide and fit on a 3/4" shaft. These will both have a 7/8" hub diameter. We do…

view full answer...

Answer 3

A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Hey Jairo. So we do not offer a direct replacement for the Norcold N611, but we do have a good replacement option for you. It really comes down to what will fit in your cutout space. Take a look at the Norcold RV Refrigerator w/ Freezer - 8.2 cu ft -…

view full answer...

Answer 11

Hey Kelvin, welcome back. To flat tow a 2026 Ford Maverick with your Demco Commander II Tow Bar item #DM9511012, I recommend the following parts: Baseplate Kit - Demco Tabless Base Plate Kit item #DM38CV Wiring Harness - Roadmaster Diode 7-Wire to…

view full answer...

3/4 Shaft Amber Keel Rollers

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching