Checking Out the Optronics Trailer Light Kit for Trailers over 80" Wide Video

Hi Ryan! The reason the Kenda 205/65-10 Bias Trailer Tire with 10" White Wheel - 5 on 4-1/2 - Load Range E #AM3H480 will not fit the etrailer Easy Grease Trailer Idler Hub Assembly for 3.5K Axles - 5 on 4-1/2 - Galvanized #AKIHUB-545-35-G-EZ-K…

A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…

Since your rescue boat trailer is 188 inches (15 feet 8-inches) tongue to tail and 89-1/2 inches (7-1/2 feet) width I recommend the following: I recommend Optronics right side LED trailer light #STL26RB and left side LED trailer light #STL27RB. They…

The "80" you are referring to is the width of the trailer, and it makes it easier to determine the light kit you need. Since you need tail lights as well as running lights, I recommend the Trailer Light Kit for Trailers Over 80" Wide…

The Mount-n-Lock Heavy-Haul'r Replacement RV Bumper #MNT78VR comes with mounting brackets but you might need the Extension Plates #MO24VR if your frame is shorter than your RV body. All of the hardware parts needed to install the bumper are…

In order to convert the incandescent tail lights on your 1998 Jayco Eagle Motorhome to LED tail lights you have a few options. You can either replace the incandescent bulbs with LED bulbs that are the same color as the housing you will be installing…

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

Depending on how the trailer was made, there will be a few spots you can check to identify the axle. First, if the trailer was pre-made by a specific company, you may be able to find this information in either the paperwork or on a placard somewhere…

I recommend using 40 Ft 5-Way Trailer Wiring Harness #A40W5B, which is a kit that will replace your entire 5 way boat wiring setup and give you the 5 way connection at the front of the trailer. The lighting wires are 40 feet long, which will be more…

I recommend etrailer.com Channel Tongue Coupler part #CT-5003-Z to replace the Shelby 5135 coupler. The etrailer.com coupler has a channel width of 3" and takes a 2" ball. It also has 3" from center of bolt hole to center of bolt hole…

Based on the information I could find for the DICO 45264 is was popular on ShoreLand'r trailers. This would require the Idler Hub #AKIHUB-545-35-G-EZ-K with the Grease Seal #168255TB used instead of the seal included with the hub. We currently do…