Recommended Replacement Door Latch For A Sundower Horse Trailer

Question

Question:

Hello there. Im struggling here. I have a 94 sundowner horse trailer. I need a new door latch. My opening as 4 3/4 x 4-34. Door thickness is 1 1/2. It has a single dead bolt. Do you have anything like this?

asked by: Jeff

0

Expert Reply:

The closest door handle we carry to your 4-3/4" x 4-3/4" cutout dimensions is the Bauer Products Keyless Entry Motorhome Door Lock - Right Hand - 8" Wide x 5" Tall Item # BA96FR which would require you to slightly alter the opening to 4-1/2" tall x 4-7/8" wide.

expert reply by: Kevin C

0

Answer 1

Hey Vicky, we have horse trailer door latches that should work well like the part #BA85FR or if it's a left handed door part #BA55FR. Let me know if what you have looks different though and I'll see what you'd need instead.

view full answer...

Answer 2

The Bauer Products Motorhome Door Lock, #BA64FR fits doors that are 1-1/4" to 1-1/2" thick and requires a cutout dimensions of at least 5-1/4" wide x 4-1/2" tall. This in no way requires a close tolerance fitment to function, so…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

Hey Clarence. There's no way to look at a tire or wheel and tell if it's a 5 on 4-1/2 or a 5 on 5 but you can take a real quick measurement to figure it out. If you'll look at the picture below you'll see a wheel with a red line on…

view full answer...

Recommended Replacement Door Latch For A Sundower Horse Trailer

Featured Help Information

Miscellaneous Media

Continue Researching