Are Thule Ladder Rack Base Rails Same as TracRac Ladder Rack Base Rails

Question

Question:

Does the Thule rails fit the Thule Tracrac system? I have a tonnou cover and want to use the current rack.

asked by: Jeff T

0

Expert Reply:

Thule owns TracRac so yes the Base Rails part # TH21610 would work with a TracRac ladder rack. This base rail is the rail kit of the part # TH43002XT-610 which fits the following:

2007 - 2021 Toyota Tundra 6-1/2 Foot Bed - with Deck Rail System
2007 - 2021 Toyota Tundra 6-1/2 Foot Bed - without Deck Rail System

expert reply by: Jameson C

0

Answer 1

The correct Thule TracRac SR sliding truck bed ladder rack for a 2018 Ford F250 long bed is part #TH43003XT-000. I've linked to a product demonstration/install video showing the rack being installed. The TracRac SR ladder rack has generous 1250…

view full answer...

Answer 2

The rails on the Thule TracRac SR #TH43002XT-782 will be as long as your truck bed rails. They are about 4 inches wide, from the bottom to the top of the inner channel they are about 1-1/4 inches and from the bottom to the top it's about 1-7/8…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

Hey Dennis! I can't say if it will clear for sure but I can give you dimensions to help determine if it will. Using the furthest hitch pin hole, the Malone 2" Dual Purpose Hitch Receiver #MPG544 will push the bike rack out 12-1/4". When…

view full answer...

Answer 10

Hello Dan, Great question. When you’re comparing the Firestone kits #F59VV and #F2582, they both technically fit your 2025 F-150, but they are designed around different mounting locations and truck configurations. The #F2582 is the traditional…

view full answer...

Answer 11

Hey Richard, yes you can set the tension in the springs of the RoadActive Suspension Kit part #RAS3611-Y low enough so that the suspension height is not raised at all. If you add in a lot more tension it will slightly affect the ride height like you…

view full answer...

Answer 12

Hey Rob, I went through the install instructions for the etrailer base plate kit part #e86YR that you referenced and did not find any mention of fit exclusions or special steps for if the truck has the air shudders/flaps that you mentioned so it…

view full answer...

Are Thule Ladder Rack Base Rails Same as TracRac Ladder Rack Base Rails

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching