Light Bulb Options for Gustafson RV Wall Sconce

Question

Question:

Our wall mount reading light fixture is listed as an E110265 fixture . What non dim able bulbs are available. The base is a wedge type

asked by: Martin

0

Expert Reply:

The Gustafson RV Wall Sconce w/ Acrylic Lens, # 277-000241-242 is designed to use either 912 or 921 bulbs.

expert reply by: Michael R

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

From what I can find the Norcold N306.3 fridge has a 2.7 cu ft capacity and is 20-1/8" wide and 26" tall. The most similar option we can offer is the 3.2 cu ft Everchill RV Mini Refrigerator #324-000111. The #324-000111 measures…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 9

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 10

Yes sir, Brian. The Buyers Products LED Light Strip #3375621827 will work with a dimmer switch. I would pair it with the JR Products LED Dimmer Switch #37205-12315, which is designed for 12V DC LED lighting in RVs. The Buyers light only draws 0.41…

view full answer...

Answer 11

Good question, Dave. The easiest way is to match the RVpaws kit to your jack leg or leveling system. For example, there are specific kits for the brands and lineups out there: Standard 2" round jack leg = #RV57FR Standard 2" square jack leg…

view full answer...

Light Bulb Options for Gustafson RV Wall Sconce

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching