Does Fastway e2 FA94-00-1061 Require Adjusting if There is Still Sag

Question

Question:

How do you know if you need to adjust the Ball Hitch Angle? I have a 16 Sierra 1500 Denali with Magnaride. It sags almost 4 inches with stock suspension and the magnaride is so stiff like I’m riding with no suspension. I added the Sumo Springs Blue now it sag 2 inches. But I’m wondering if I need to adjust the ball angle.

asked by: Richard L

0

Expert Reply:

If you still have sag, it is possible that the angle of the hitch ball needs to be adjusted, though technically you would be adjusting the head of the Fastway e2 Weight Distribution with 2-Point Sway Control # FA94-00-1061.

I have added a link below to the instruction manual for you to check out as well of the Fastway e2 Weight Distribution with 2-Point Sway Control # FA94-00-1061.

expert reply by: Kyle S

0

Answer 1

With the coil spring suspension enhancement kits like the part #AL60812 that fits the stock suspension of your 2007 Toyota Sequoia there isn't a spacer or way to make them taller if you were to add a lift that increased the travel of the…

view full answer...

Answer 2

For your extra drop needed with your Fastway E2 weight distribution system, I recommend the Fastway e2 Weight Distribution Shank - 12" Long - 10-3/4" Rise, 5-1/2" Drop - 1,200 lbs TW #FA92-02-4214 this will give you a little under 4…

view full answer...

Answer 3

Even though a 1" lift probably isn't going to considerably change your setup, if your trailer was level/close to level before adding a RoadActive RAS system like the #RAS3611-Y , you'll need to make some adjustments. If your trailer is…

view full answer...

Answer 4

Since everything else is working on your Redarc Tow-Pro Liberty Brake Controller #RED24FR there may be a problem with the light pipe on the control knob. there is a 90 degree light pipe which is what brings the light up and out through the button. If…

view full answer...

Answer 5

It looks to me that you will want additional spacers to provide better weight distribution on your 2019 Ram 1500. The Fast Way e2 Weight-Distribution Hitch #FA94-00-1061 is capable of having up to 9 spacers to provide the correct pinion angle on the…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Does Fastway e2 FA94-00-1061 Require Adjusting if There is Still Sag

Featured Help Information

Miscellaneous Media

Continue Researching