Will Timbren System # TGMFK35C Fit 1995 Chevrolet Tahoe With Torsion Bar Front Suspension
Updated 03/08/2013 | Published 03/05/2013
Products Featured in This Question
Question:
vehicle: 1995 Chevrolet Tahoe Will the Timbren TGMFK35C front suspension enhacement kit work on my 1995 Tahoe 4x4 with torsion bar front suspension? If not, what might you recommend to help support a snow plow?
asked by: Dale B
Helpful Expert Reply:
The Timbren Front Suspension Enhancement System, part # TGMFK35C, will fit your 1995 Chevrolet Tahoe 4WD with torsion bar front suspension. The Timbren rubber springs will install in place of your factory bump stop. You will want to make sure that the suspension on your vehicle is in good working order before installing the Timbren kit.
The Timbren kit is designed to work on vehicles with a snow plow. The rubber springs will raise the front of the end of the Tahoe when heavy equipment, such as a plow, is attached. Headlight beams will be pointed in the right direction and tire wear will be reduced. If the plow is off center or has an extension, the hollow rubber springs will automatically compensate for this as well.
If you wanted to upgrade the rear suspension on your Tahoe the kit for the rear would be the Timbren Rear Suspension Enhancement System, part # TGMRYT4.
I am including a link to the installation instructions on the Timbren system.
Product Page this Question was Asked From
Timbren Front Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Extra Heavy Duty
- Front Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Suspension Enhancement
- Shop: Timbren Front Suspension Enhancement System
- Shop: Timbren Front Suspension Enhancement System
- Shop: Trailer Hitch
- Shop: Timbren Rear Suspension Enhancement System
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Shop: Timbren 1" Spacer For Raised Frame Vehicles - 3/8" Bushing
- Shop: B&W Heavy-Duty Trailer Hitch Receiver - Custom Fit - Class V - 2"
- Search Results: hitch
- Shop: Front Mount Hitch
- Shop: Performance Chip Tuners
- Shop: Timbren Front Suspension Enhancement System
- Shop: Vehicle Snow Plows
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: trailer hitch
- Shop: Trailer Wiring
- Article: Trailer Wiring Diagrams
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Search Results: trailer wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Search Results: trailer tires and wheels
- Q&A: Should I Get Loadlifter 5000 Or 7500 For Towing A 15K Fifth Wheel
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Shop: Brake Controller
- Search Results: suspension enhancement
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Comparing the Curt Hitch C13416 and EcoHitch Hitch 306-X7396 for a 2019 Toyota RAV4
on Vehicle Suspension
