Replacement Door Latch for 1987 Airstream Excella

Question

Question:

need an entry door latch for an Airstream travel trailer. It is a 1987 Excella.

asked by: Darlene M

0

Expert Reply:

I may have a solution for you, but we don't have specific information as to what type of latch or the size of the cutout that is on specific trailers. However, something like the Global Link RV Entry Door Locking Latch Kit with Keyed Alike Option - Black # 295-000019 might work well for you. This lock is designed for door cutouts that are from 2-1/2" wide x 3-1/2" tall up to 3" wide x 4" tall, and doors that are between 1-1/4" and 1-1/2" and can be keyed alike if you've got more than one door that you're looking to replace the latch on.

I've linked our entire selection of door latches for you to check out, but if you can provide a photo and dimensions of the latch you're looking to replace I might be able to find a better solution.

expert reply by: Erik B

0

Answer 1

From our experience the brake controller connector on a Toyota Sequoia is pretty tucked away. It's in a similar location as to the Tundra video you watched but harder to find. Take a look at the video I linked of the 2008 Sequoia, it's the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

The best brake controller option to go with is one that activates the brakes proportionally instead of time delayed. A proportional brake controller will activate the trailer brakes at the same time and with the same intensity as the tow vehicle…

view full answer...

Answer 9

Both the Dexter Electric Trailer Brake Kit #23-47-48 and the Electric Trailer Brake Kit #AKEBRK-2 are excellent options to replace the brake assemblies on your 2009 Palomino Pony pop-up camper. A lot of the Dexter Axle kit price comes from the name…

view full answer...

Replacement Door Latch for 1987 Airstream Excella

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching