Hardware Kit for the Curt Lunette Ring - Flat Plate Mount

Question

Question:

Curt Lunette Ring - Flat Plate Mount - 3 Diameter - 60,000 lbs - C48560 What is the recommended hardware to install this Lunette Ring?

asked by: Eduardo E

0

Expert Reply:

To mount the Curt Lunette Ring - Flat Plate Mount - 3" Diameter - 60,000 lbs, part # C48560, you can use the Lunette Ring Hardware Kit - Flush Mount, part # C48KR. It includes four 3/4" hex bolts, four nylock nuts and four flat washers.

I've linked to a video review of the lunette ring for your reference.

expert reply by: Kef G

0

Answer 1

The bolts in The Curt Lunette Ring Hardware Kit #C48KR are 3/4 inches, 10tpi and 2.5 inches long. They are a grade eight bolt.. They will extend through 1 plate and you can fasten the nut on.

view full answer...

Answer 2

I called a few of our pintle hook manufacturers as well as went out to our warehouse to measure some for you. Unfortunately, none of them will accept a 2" thick lunette ring. The majority of them are designed for a 1-3/4" thick ring like…

view full answer...

Answer 3

On your 2010 Ford Explorer Sport Trac the factory plug for your brake controller will be located under the dash, on the left side of the steering wheel, just above your left leg. The wiring adapter you will need to connect the Draw-Tite Brake…

view full answer...

Answer 4

I attached a chart that has the automotive cross reference for the Kodiak disc brake pads part #K2250CP that you referenced under the yellow heading. Probably the easiest to look up would be 1982 to 1992 Chevy Cavalier.

view full answer...

Answer 5

If you didn't have a battery used with your breakaway system there'd be nothing to power the brakes in the event of a disconnect so you couldn't use just a switch like the part #FA80-00-2040 by itself. You'd instead need to use a…

view full answer...

Answer 6

For a 2013 Honda CR-V we have the Blue Ox Base Plate Kit - Removable Arms #BX2258 that will work well with your Blue Ox Tow Bar. I recommend using Loctite Threadlocker #LT37420 for this installation. For your vehicle wiring, I recommend the Hopkins…

view full answer...

Answer 7

I called my contact at Buyers Products and they informed me that the Buyers Products Welded Mount Lunette Ring part #337BDB125015W is 5-1/2" x 5-1/2" and the mounting holes are all 4-1/2" apart top to bottom and side to side. I have…

view full answer...

Hardware Kit for the Curt Lunette Ring - Flat Plate Mount

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching