1994 Four Star Horse Trailer Replacement Locking Latch

Question

Question:

1994 four star horse trailer dressing room replacement locking latch for Dressing room door

asked by: Robin

0

Expert Reply:

You can definitely try the Full Size Locking Steel Flush Door Latch Item # L3980 but the opening for the original lock may have to modified to accommodate the new latch. We do not offer that type of locking door latch or a latch that size that could replace it. I recommend contacting the manufacturer of the actual door latch to see if there may be a direct replacement.

expert reply by: Shane H

0

click to enlarge

Answer 1

The best hitch for a 2024 Toyota Sienna is the Curt item #C22UR. This hitch is custom fit and bolts to your Toyota with included hardware. It is a class III hitch with a 2" receiver that has a 3,500 lbs towing capacity and a 350 lbs maximum…

view full answer...

Answer 2

All of the replacement vent lids we offer are designed to fit 14-1/4 by 14-1/4 inch roof vents (typically referred to as 14 x14). We do not have a lid recommendation I could make for a 12 by 12 inch vent. The only suggestion I can make is recommend a…

view full answer...

Answer 3

I'm not sure what kind of hingers you had on your trailer but a T-strap hinge like the #PLR2212-AS or #PLR3408-SS is probably your best bet for replacement. I went ahead and attached a link below to all of our available hinges. You can filter…

view full answer...

Answer 4

I might have an option for you but we don't offer any flush door latches with an extended striker. However, the Full Size Locking Steel Flush Door Latch part #L3980 matches your door cutout at 4-5/8" long x 3-3/8" so this is our best…

view full answer...

Answer 5

Hi Tracy, thanks for reaching out. If the measurements you provided (about 5-1/4" tall by 5-5/8" wide) are the cutout size, the closest option we have is the Bauer Products Motorhome Door Lock #BA64FR. That lock is designed for a…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The wires exiting the rear of your controller serve the following functions. The blue wires carries the brake output from the controller, the white wire is the ground, the black wire supplies 12 Volt power, and the red wire is tied into the vehicle…

view full answer...

Answer 8

If you need to find the size of the correct replacement braking assembly for your boat trailer you will need to remove the trailer hub and measure the inside contact patch with the shoes which you can see in the attached photo. You will also want to…

view full answer...

Answer 9

You can use the Pollack #PK11700 to install on your gooseneck trailer and create a 7 way plug capable of fitting on the 7 pole round plug that is on a semi tractor trailer truck. For the wiring you can use the Deka Jacketed 7 Wire #DW04914-1 which is…

view full answer...

Answer 10

Hello Phillip. The brake assemblies rated between 5,200 lbs and 7,000 lbs are all the same size. They use the same 5 bolt pattern for the mounting flange and the brake shoes are 12" x 2". So, yes, you can use Dexter 7,000 lb brake…

view full answer...

1994 Four Star Horse Trailer Replacement Locking Latch

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching