Disassembling Valterra Rocket Hand Pump To Install Repair Kit
Updated 04/28/2026 | Published 12/15/2020
Question:
How do you take it apart? Took all the screws off the nuts but the would not come off. What the secret?
asked by: Ed
Helpful Expert Reply:
I reached out to Valterra and to disassemble your Valterra Rocket Hand Pump # RP800 to install the Repair Kit # RP320 you are correct that first you will need to remove the screws from the bottom of the pump.
My contact said that the seal between the black and chrome pieces is very sticky and the best way to get it to loosen up is to place the hand pump in hot water, but not boiling water, for roughly 10 minutes to help loosen the seal.
Once you pull the pump out of the water you will need to use a flat head screw driver to gently pry the black and chrome pieces apart by prying in different areas across the perimeter. As long as you pry slowly you will be able to separate the two pieces without damage.
Product Page this Question was Asked From
Repair Kit for Valterra Rocket Hand Pump
- Accessories and Parts
- RV Water Pump
- Hand Pump Parts
- Repair Kit
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Karrier ST205/75R14 KR53 Radial Trailer Tire - Load Range D
- Shop: Repair Kit for Valterra Rocket Hand Pump
- Search Results: trailer tires and wheels
- Q&A: Comparing Trailer King RST To Kenda Loadstar ST Tires
- Video: Checking Out the Loctite RTV 5699 High-Performance Silicone Gasket Maker
- Shop: Kenda Karrier KR53 ST205/75R14 Radial Trailer Tire with 14" Black Mod Wheel - 5 on 4-1/2
- Shop: Kenda ST205/75D14 Bias Trailer Tire - Load Range C
- Shop: Loctite RTV 5699 High-Performance Silicone Gasket Maker - Grey - 2.7-Fl Oz Tube
- Q&A: What Size is the Seal in Repair Kit for Valterra Rocket Hand Pump # RP320
- Q&A: Using The RV Hand Pump Water Faucet With A Reliance Aquatainer Water Jug
- Shop: RV Hand Pump Water Faucet - 1/4" MPT - Chrome
- Q&A: How to Determine the Right Air Pressure to Fill a Trailer Tire
- Q&A: Should Trailer Tires Always be Inflated to Their Max PSI
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Search Results: trailer hitch
- Shop: Trailer Hitch
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Article: Trailer Wiring Diagrams
- Video: A Look at the Power Mountain Tallboy 6 Ton Off-Road Bottle Jack with a Military Cargo Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Shop: Trailer Wiring
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Video: Measuring To Choose The Right Trailer Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Search Results: trailer wiring
- Shop: Suspension Enhancement
- Search Results: trailer jack
- Video: Hands-On with the Hub Saver Hub and Wheel Protector
- Article: Trailer Lighting Requirements
- Shop: Brake Controller
on Accessories and Parts
Guy K.
4/28/2026
What kind of compound should be used to reseal the bottom of the pump after you replace the parts